diff options
Diffstat (limited to 'drivers/mmc/host/mmc_spi.c')
| -rw-r--r-- | drivers/mmc/host/mmc_spi.c | 17 |
1 files changed, 11 insertions, 6 deletions
diff --git a/drivers/mmc/host/mmc_spi.c b/drivers/mmc/host/mmc_spi.c index 19544b121276..951f76dc1ddd 100644 --- a/drivers/mmc/host/mmc_spi.c +++ b/drivers/mmc/host/mmc_spi.c @@ -891,7 +891,7 @@ mmc_spi_data_do(struct mmc_spi_host *host, struct mmc_command *cmd, /* Handle scatterlist segments one at a time, with synch for * each 512-byte block */ - for (sg = data->sg, n_sg = data->sg_len; n_sg; n_sg--, sg++) { + for_each_sg(data->sg, sg, data->sg_len, n_sg) { int status = 0; dma_addr_t dma_addr = 0; void *kmap_addr; @@ -1134,17 +1134,22 @@ static void mmc_spi_initsequence(struct mmc_spi_host *host) * SPI protocol. Another is that when chipselect is released while * the card returns BUSY status, the clock must issue several cycles * with chipselect high before the card will stop driving its output. + * + * SPI_CS_HIGH means "asserted" here. In some cases like when using + * GPIOs for chip select, SPI_CS_HIGH is set but this will be logically + * inverted by gpiolib, so if we want to ascertain to drive it high + * we should toggle the default with an XOR as we do here. */ - host->spi->mode |= SPI_CS_HIGH; + host->spi->mode ^= SPI_CS_HIGH; if (spi_setup(host->spi) != 0) { /* Just warn; most cards work without it. */ dev_warn(&host->spi->dev, "can't change chip-select polarity\n"); - host->spi->mode &= ~SPI_CS_HIGH; + host->spi->mode ^= SPI_CS_HIGH; } else { mmc_spi_readbytes(host, 18); - host->spi->mode &= ~SPI_CS_HIGH; + host->spi->mode ^= SPI_CS_HIGH; if (spi_setup(host->spi) != 0) { /* Wot, we can't get the same setup we had before? */ dev_err(&host->spi->dev, @@ -1421,7 +1426,7 @@ static int mmc_spi_probe(struct spi_device *spi) * Index 0 is card detect * Old boardfiles were specifying 1 ms as debounce */ - status = mmc_gpiod_request_cd(mmc, NULL, 0, false, 1, NULL); + status = mmc_gpiod_request_cd(mmc, NULL, 0, false, 1000); if (status == -EPROBE_DEFER) goto fail_add_host; if (!status) { @@ -1436,7 +1441,7 @@ static int mmc_spi_probe(struct spi_device *spi) mmc_detect_change(mmc, 0); /* Index 1 is write protect/read only */ - status = mmc_gpiod_request_ro(mmc, NULL, 1, 0, NULL); + status = mmc_gpiod_request_ro(mmc, NULL, 1, 0); if (status == -EPROBE_DEFER) goto fail_add_host; if (!status) |
