diff options
Diffstat (limited to 'Documentation/devicetree/bindings/serial/fsl-lpuart.txt')
| -rw-r--r-- | Documentation/devicetree/bindings/serial/fsl-lpuart.txt | 10 |
1 files changed, 7 insertions, 3 deletions
diff --git a/Documentation/devicetree/bindings/serial/fsl-lpuart.txt b/Documentation/devicetree/bindings/serial/fsl-lpuart.txt index 21483ba820bc..c904e2e68332 100644 --- a/Documentation/devicetree/bindings/serial/fsl-lpuart.txt +++ b/Documentation/devicetree/bindings/serial/fsl-lpuart.txt @@ -10,16 +10,20 @@ Required properties: on i.MX7ULP SoC with 32-bit little-endian register organization - "fsl,imx8qxp-lpuart" for lpuart compatible with the one integrated on i.MX8QXP SoC with 32-bit little-endian register organization + - "fsl,imx8qm-lpuart" for lpuart compatible with the one integrated + on i.MX8QM SoC with 32-bit little-endian register organization - reg : Address and length of the register set for the device - interrupts : Should contain uart interrupt - clocks : phandle + clock specifier pairs, one for each entry in clock-names -- clock-names : should contain: "ipg" - the uart clock +- clock-names : For vf610/ls1021a/imx7ulp, "ipg" clock is for uart bus/baud + clock. For imx8qxp lpuart, "ipg" clock is bus clock that is used to access + lpuart controller registers, it also requires "baud" clock for module to + receive/transmit data. Optional properties: - dmas: A list of two dma specifiers, one for each entry in dma-names. - dma-names: should contain "tx" and "rx". -- rs485-rts-delay, rs485-rts-active-low, rs485-rx-during-tx, - linux,rs485-enabled-at-boot-time: see rs485.txt +- rs485-rts-active-low, linux,rs485-enabled-at-boot-time: see rs485.txt Note: Optional properties for DMA support. Write them both or both not. |
