input: TSC: ti_tscadc: Correct register usage

This patch cleans up the wrong register definitions
and usage for touchscreen controller.
Bit masks were not defined earlier.

For ex: consider a register define as:
write(xyz, ABC)
ABC is expected to be written to register bits 0-11.
Here we see that value written is as expected, but this write
is also affecting all the remaining bits of xyz.
The remaining bits hold the default value as 0 and the write
also sets it to zero. Hence wrong usage were not causing user
visible bugs.
Due to these reasons it was difficult to follow when
compared with TRM.

Unused definitions are also removed.
Since there is change in some naming convention because of
all the above mentioned reasons, the same has been
updated throughout the code.
Bit declarations are grouped to increase readability.

Signed-off-by: Patil, Rachna <rachna@ti.com>
Signed-off-by: Samuel Ortiz <sameo@linux.intel.com>

1 files changed, 82 insertions, 46 deletions

diff --git a/drivers/input/touchscreen/ti_tscadc.c b/drivers/input/touchscreen/ti_tscadc.c
index d229c741d544..d198cab61a69 100644
--- a/drivers/input/touchscreen/ti_tscadc.c
+++ b/drivers/input/touchscreen/ti_tscadc.c
@@ -52,43 +52,79 @@
 
 /*	Register Bitfields	*/
 #define IRQWKUP_ENB		BIT(0)
-#define STPENB_STEPENB		0x7FFF
+
+/* Step Enable */
+#define STEPENB_MASK		(0x1FFFF << 0)
+#define STEPENB(val)		(val << 0)
+#define STPENB_STEPENB		STEPENB(0x7FFF)
+
+/* IRQ enable */
 #define IRQENB_FIFO1THRES	BIT(5)
 #define IRQENB_PENUP		BIT(9)
-#define STEPCONFIG_MODE_HWSYNC	0x2
-#define STEPCONFIG_SAMPLES_AVG	(1 << 4)
-#define STEPCONFIG_XPP		(1 << 5)
-#define STEPCONFIG_XNN		(1 << 6)
-#define STEPCONFIG_YPP		(1 << 7)
-#define STEPCONFIG_YNN		(1 << 8)
-#define STEPCONFIG_XNP		(1 << 9)
-#define STEPCONFIG_YPN		(1 << 10)
-#define STEPCONFIG_INM		(1 << 18)
-#define STEPCONFIG_INP		(1 << 20)
-#define STEPCONFIG_INP_5	(1 << 21)
-#define STEPCONFIG_FIFO1	(1 << 26)
-#define STEPCONFIG_OPENDLY	0xff
-#define STEPCONFIG_Z1		(3 << 19)
-#define STEPIDLE_INP		(1 << 22)
-#define STEPCHARGE_RFP		(1 << 12)
-#define STEPCHARGE_INM		(1 << 15)
-#define STEPCHARGE_INP		(1 << 19)
-#define STEPCHARGE_RFM		(1 << 23)
-#define STEPCHARGE_DELAY	0x1
-#define CNTRLREG_TSCSSENB	(1 << 0)
-#define CNTRLREG_STEPID		(1 << 1)
-#define CNTRLREG_STEPCONFIGWRT	(1 << 2)
-#define CNTRLREG_4WIRE		(1 << 5)
-#define CNTRLREG_5WIRE		(1 << 6)
-#define CNTRLREG_8WIRE		(3 << 5)
-#define CNTRLREG_TSCENB		(1 << 7)
-#define ADCFSM_STEPID		0x10
 
+/* Step Configuration */
+#define STEPCONFIG_MODE_MASK	(3 << 0)
+#define STEPCONFIG_MODE(val)	(val << 0)
+#define STEPCONFIG_MODE_HWSYNC	STEPCONFIG_MODE(2)
+#define STEPCONFIG_AVG_MASK	(7 << 2)
+#define STEPCONFIG_AVG(val)	(val << 2)
+#define STEPCONFIG_AVG_16	STEPCONFIG_AVG(4)
+#define STEPCONFIG_XPP		BIT(5)
+#define STEPCONFIG_XNN		BIT(6)
+#define STEPCONFIG_YPP		BIT(7)
+#define STEPCONFIG_YNN		BIT(8)
+#define STEPCONFIG_XNP		BIT(9)
+#define STEPCONFIG_YPN		BIT(10)
+#define STEPCONFIG_INM_MASK	(0xF << 15)
+#define STEPCONFIG_INM(val)	(val << 15)
+#define STEPCONFIG_INM_ADCREFM	STEPCONFIG_INM(8)
+#define STEPCONFIG_INP_MASK	(0xF << 19)
+#define STEPCONFIG_INP(val)	(val << 19)
+#define STEPCONFIG_INP_AN2	STEPCONFIG_INP(2)
+#define STEPCONFIG_INP_AN3	STEPCONFIG_INP(3)
+#define STEPCONFIG_INP_AN4	STEPCONFIG_INP(4)
+#define STEPCONFIG_INP_ADCREFM	STEPCONFIG_INP(8)
+#define STEPCONFIG_FIFO1	BIT(26)
+
+/* Delay register */
+#define STEPDELAY_OPEN_MASK	(0x3FFFF << 0)
+#define STEPDELAY_OPEN(val)	(val << 0)
+#define STEPCONFIG_OPENDLY	STEPDELAY_OPEN(0x098)
+
+/* Charge Config */
+#define STEPCHARGE_RFP_MASK	(7 << 12)
+#define STEPCHARGE_RFP(val)	(val << 12)
+#define STEPCHARGE_RFP_XPUL	STEPCHARGE_RFP(1)
+#define STEPCHARGE_INM_MASK	(0xF << 15)
+#define STEPCHARGE_INM(val)	(val << 15)
+#define STEPCHARGE_INM_AN1	STEPCHARGE_INM(1)
+#define STEPCHARGE_INP_MASK	(0xF << 19)
+#define STEPCHARGE_INP(val)	(val << 19)
+#define STEPCHARGE_INP_AN1	STEPCHARGE_INP(1)
+#define STEPCHARGE_RFM_MASK	(3 << 23)
+#define STEPCHARGE_RFM(val)	(val << 23)
+#define STEPCHARGE_RFM_XNUR	STEPCHARGE_RFM(1)
+
+/* Charge delay */
+#define CHARGEDLY_OPEN_MASK	(0x3FFFF << 0)
+#define CHARGEDLY_OPEN(val)	(val << 0)
+#define CHARGEDLY_OPENDLY	CHARGEDLY_OPEN(1)
+
+/* Control register */
+#define CNTRLREG_TSCSSENB	BIT(0)
+#define CNTRLREG_STEPID		BIT(1)
+#define CNTRLREG_STEPCONFIGWRT	BIT(2)
+#define CNTRLREG_AFE_CTRL_MASK	(3 << 5)
+#define CNTRLREG_AFE_CTRL(val)	(val << 5)
+#define CNTRLREG_4WIRE		CNTRLREG_AFE_CTRL(1)
+#define CNTRLREG_5WIRE		CNTRLREG_AFE_CTRL(2)
+#define CNTRLREG_8WIRE		CNTRLREG_AFE_CTRL(3)
+#define CNTRLREG_TSCENB		BIT(7)
+
+#define ADCFSM_STEPID		0x10
 #define SEQ_SETTLE		275
 #define ADC_CLK			3000000
 #define MAX_12BIT		((1 << 12) - 1)
-#define TSCADC_DELTA_X		15
-#define TSCADC_DELTA_Y		15
 
 struct tscadc {
 	struct input_dev	*input;
@@ -119,18 +155,18 @@ static void tscadc_step_config(struct tscadc *ts_dev)
 	/* Configure the Step registers */
 
 	config = STEPCONFIG_MODE_HWSYNC |
-			STEPCONFIG_SAMPLES_AVG | STEPCONFIG_XPP;
+			STEPCONFIG_AVG_16 | STEPCONFIG_XPP;
 	switch (ts_dev->wires) {
 	case 4:
-		config |= STEPCONFIG_INP | STEPCONFIG_XNN;
+		config |= STEPCONFIG_INP_AN2 | STEPCONFIG_XNN;
 		break;
 	case 5:
 		config |= STEPCONFIG_YNN |
-				STEPCONFIG_INP_5 | STEPCONFIG_XNN |
+				STEPCONFIG_INP_AN4 | STEPCONFIG_XNN |
 				STEPCONFIG_YPP;
 		break;
 	case 8:
-		config |= STEPCONFIG_INP | STEPCONFIG_XNN;
+		config |= STEPCONFIG_INP_AN2 | STEPCONFIG_XNN;
 		break;
 	}
 
@@ -141,14 +177,14 @@ static void tscadc_step_config(struct tscadc *ts_dev)
 
 	config = 0;
 	config = STEPCONFIG_MODE_HWSYNC |
-			STEPCONFIG_SAMPLES_AVG | STEPCONFIG_YNN |
-			STEPCONFIG_INM | STEPCONFIG_FIFO1;
+			STEPCONFIG_AVG_16 | STEPCONFIG_YNN |
+			STEPCONFIG_INM_ADCREFM | STEPCONFIG_FIFO1;
 	switch (ts_dev->wires) {
 	case 4:
 		config |= STEPCONFIG_YPP;
 		break;
 	case 5:
-		config |= STEPCONFIG_XPP | STEPCONFIG_INP_5 |
+		config |= STEPCONFIG_XPP | STEPCONFIG_INP_AN4 |
 				STEPCONFIG_XNP | STEPCONFIG_YPN;
 		break;
 	case 8:
@@ -164,21 +200,21 @@ static void tscadc_step_config(struct tscadc *ts_dev)
 	config = 0;
 	/* Charge step configuration */
 	config = STEPCONFIG_XPP | STEPCONFIG_YNN |
-			STEPCHARGE_RFP | STEPCHARGE_RFM |
-			STEPCHARGE_INM | STEPCHARGE_INP;
+			STEPCHARGE_RFP_XPUL | STEPCHARGE_RFM_XNUR |
+			STEPCHARGE_INM_AN1 | STEPCHARGE_INP_AN1;
 
 	tscadc_writel(ts_dev, REG_CHARGECONFIG, config);
-	tscadc_writel(ts_dev, REG_CHARGEDELAY, STEPCHARGE_DELAY);
+	tscadc_writel(ts_dev, REG_CHARGEDELAY, CHARGEDLY_OPENDLY);
 
 	config = 0;
 	/* Configure to calculate pressure */
 	config = STEPCONFIG_MODE_HWSYNC |
-			STEPCONFIG_SAMPLES_AVG | STEPCONFIG_YPP |
-			STEPCONFIG_XNN | STEPCONFIG_INM;
+			STEPCONFIG_AVG_16 | STEPCONFIG_YPP |
+			STEPCONFIG_XNN | STEPCONFIG_INM_ADCREFM;
 	tscadc_writel(ts_dev, REG_STEPCONFIG13, config);
 	tscadc_writel(ts_dev, REG_STEPDELAY13, STEPCONFIG_OPENDLY);
 
-	config |= STEPCONFIG_Z1 | STEPCONFIG_FIFO1;
+	config |= STEPCONFIG_INP_AN3 | STEPCONFIG_FIFO1;
 	tscadc_writel(ts_dev, REG_STEPCONFIG14, config);
 	tscadc_writel(ts_dev, REG_STEPDELAY14, STEPCONFIG_OPENDLY);
 
@@ -190,8 +226,8 @@ static void tscadc_idle_config(struct tscadc *ts_config)
 	unsigned int idleconfig;
 
 	idleconfig = STEPCONFIG_YNN |
-			STEPCONFIG_INM |
-			STEPCONFIG_YPN | STEPIDLE_INP;
+			STEPCONFIG_INM_ADCREFM |
+			STEPCONFIG_YPN | STEPCONFIG_INP_ADCREFM;
 	tscadc_writel(ts_config, REG_IDLECONFIG, idleconfig);
 }