PCI: designware: Parse bus-range property from devicetree

This allows to explicitly specify the covered bus numbers in the
devicetree, which will come in handy once we see a SoC with more than one
PCIe host controller instance.

Previously the driver relied on the behavior of pci_scan_root_bus() to fill
in a range of 0x00-0xff if no valid range was found.  We fall back to the
same range if no valid DT entry was found to keep backwards compatibility,
but now do it explicitly.

[bhelgaas: use %pR in error message to avoid duplication]
Signed-off-by: Lucas Stach <l.stach@pengutronix.de>
Signed-off-by: Bjorn Helgaas <bhelgaas@google.com>
Reviewed-by: Pratyush Anand <pratyush.anand@st.com>
Acked-by: Mohit Kumar <mohit.kumar@st.com>

1 files changed, 3 insertions, 0 deletions

diff --git a/Documentation/devicetree/bindings/pci/designware-pcie.txt b/Documentation/devicetree/bindings/pci/designware-pcie.txt
index ed0d9b9fff2b..9f4faa8e8d00 100644
--- a/Documentation/devicetree/bindings/pci/designware-pcie.txt
+++ b/Documentation/devicetree/bindings/pci/designware-pcie.txt
@@ -23,3 +23,6 @@ Required properties:
 
 Optional properties:
 - reset-gpio: gpio pin number of power good signal
+- bus-range: PCI bus numbers covered (it is recommended for new devicetrees to
+  specify this property, to keep backwards compatibility a range of 0x00-0xff
+  is assumed if not present)