summaryrefslogtreecommitdiffstats
path: root/src
Commit message (Expand)AuthorAgeFilesLines
* Memory:MPV:STC920:Zeppelin: OCC held in reset after a channel checkstopDouglas Gilbert2018-08-0710-80/+325
* Add WOF parameters to WOF error logsAndres Lugo-Reyes2018-07-236-5/+14
* Update occtoolp9 to handle parsing WOF Reset reason in opal-prdAndres Lugo-Reyes2018-07-131-1/+55
* Prevent calling out Centaurs on clock failovermbroyles2018-07-126-89/+26
* Increase GPE1 Stack SizeWilliam Bryan2018-07-061-2/+2
* Prevent calling out DIMMs and Centaurs due to GPE issuesmbroyles2018-06-297-5/+66
* Fix PGPE beacon detectionChris Cain2018-06-212-1/+2
* Fix DIMM callout on temperature timeoutChris Cain2018-06-148-22/+253
* WOF: Add Extended RC to wof errorsAndres Lugo-Reyes2018-06-059-71/+212
* Fix units in comments in OPPB to match ekb and actual units.Andres Lugo-Reyes2018-06-051-12/+12
* Tool to parse raw WOF hex dataAndres Lugo-Reyes2018-05-314-138/+683
* WOF Reset debug commandAndres Lugo-Reyes2018-05-315-8/+38
* 24x7: Added Alink PMU & fix for defect SW430218Sumit Kumar2018-05-312-13/+161
* captureFir: Add delay and sbefifo resetDouglas Gilbert2018-05-293-5/+64
* Force update of OPAL-OCC memory after GPU presence detectedmbroyles2018-05-252-1/+7
* Enable GPE IPC TimersWilliam Bryan2018-05-171-1/+4
* Redundant APSS SupportAndres Lugo-Reyes2018-05-161-2/+2
* Package the g_wof struct so debug command data is consistentAndres Lugo-Reyes2018-05-141-1/+1
* Update GPE1 Binary 5/10/18William Bryan2018-05-101-1/+1
* Add GPU presence to OPAL shared memory interfacembroyles2018-05-092-2/+29
* Centaur SYNC required after changing throttleDouglas Gilbert2018-05-076-55/+123
* Increase pgpe clip timeout to 500usAndres Lugo-Reyes2018-05-032-2/+2
* Fix reading EMPATH data from fused odd numbered coresDouglas Gilbert2018-05-034-4/+45
* 24x7 gpe1: Added version structureSumit Kumar2018-05-022-1880/+1958
* Don't return APSS channel data for GPUs not presentmbroyles2018-04-252-9/+25
* Update GPE1 Binary 4/24William Bryan2018-04-241-1/+1
* Fix using UT before WOF is fully enabled when running with OPALmbroyles2018-04-242-3/+22
* OCC Centaur: Check for channel checkstopDouglas Gilbert2018-04-208-138/+350
* AVSBus Vdd Current roll over workaroundmbroyles2018-04-1620-390/+251
* Remove disable of Pstates on a transition to standby statembroyles2018-04-122-13/+3
* Fix compile issue in op-build environmentWilliam Bryan2018-04-102-107/+3
* OCC Centaur enable deadman timerDouglas Gilbert2018-04-102-2/+2
* Use Turbo for max frequency until WOF is fully enabledChris Cain2018-04-103-14/+14
* OCC Centaur disable deadman timer and clean up codeDoug Gilbert2018-04-046-254/+35
* Minor fix for GPU reset SM and more FFDCWilliam Bryan2018-04-021-5/+6
* Prevent Nimbus tasks from running prior to knowing memory typembroyles2018-04-025-15/+17
* P9 Centaur sensor supportDoug Gilbert2018-03-2834-648/+4183
* Fix DIMM overtemp bitmap and and trace updatesChris Cain2018-03-283-26/+31
* Memory Throttle SensorsWilliam Bryan2018-03-2717-139/+314
* Regulator N mode supportmbroyles2018-03-129-4/+112
* Try to PCAP GPU again after busy failureWilliam Bryan2018-03-075-33/+75
* WOF: Force ceff_ratio to 0% if voltage component is 0Andres Lugo-Reyes2018-03-061-53/+61
* Buildname 3/1William Bryan2018-03-011-1/+1
* WOF: Phase 2 Vratio calculation correctionAndres Lugo-Reyes2018-03-012-5/+6
* Support set data length command to improve AMESTER performance with Open BMCmbroyles2018-03-013-21/+53
* Correct ASM WOF enable adjusted valuembroyles2018-02-221-1/+1
* Look at OCCFLG[30] to see if PGPE needs a new VFRTAndres Lugo-Reyes2018-02-192-50/+73
* Characterization state meltbox supportmbroyles2018-02-168-339/+300
* Replace Firmware Level with FClip History in error logAndres Lugo-Reyes2018-02-1217-73/+142
* Enable 24x7 on FSP systemsmbroyles2018-02-061-8/+0
OpenPOWER on IntegriCloud