diff options
Diffstat (limited to 'board/compulab/cm_fx6')
| -rw-r--r-- | board/compulab/cm_fx6/cm_fx6.c | 95 |
1 files changed, 87 insertions, 8 deletions
diff --git a/board/compulab/cm_fx6/cm_fx6.c b/board/compulab/cm_fx6/cm_fx6.c index 84e36439fa..ae6945ba9c 100644 --- a/board/compulab/cm_fx6/cm_fx6.c +++ b/board/compulab/cm_fx6/cm_fx6.c @@ -15,19 +15,86 @@ #include <netdev.h> #include <fdt_support.h> #include <sata.h> +#include <splash.h> #include <asm/arch/crm_regs.h> #include <asm/arch/sys_proto.h> #include <asm/arch/iomux.h> +#include <asm/arch/mxc_hdmi.h> #include <asm/imx-common/mxc_i2c.h> #include <asm/imx-common/sata.h> +#include <asm/imx-common/video.h> #include <asm/io.h> #include <asm/gpio.h> #include <dm/platform_data/serial_mxc.h> #include "common.h" #include "../common/eeprom.h" +#include "../common/common.h" DECLARE_GLOBAL_DATA_PTR; +#ifdef CONFIG_SPLASH_SCREEN +static struct splash_location cm_fx6_splash_locations[] = { + { + .name = "sf", + .storage = SPLASH_STORAGE_SF, + .offset = 0x100000, + }, +}; + +int splash_screen_prepare(void) +{ + return splash_source_load(cm_fx6_splash_locations, + ARRAY_SIZE(cm_fx6_splash_locations)); +} +#endif + +#ifdef CONFIG_IMX_HDMI +static void cm_fx6_enable_hdmi(struct display_info_t const *dev) +{ + imx_enable_hdmi_phy(); +} + +struct display_info_t const displays[] = { + { + .bus = -1, + .addr = 0, + .pixfmt = IPU_PIX_FMT_RGB24, + .detect = detect_hdmi, + .enable = cm_fx6_enable_hdmi, + .mode = { + .name = "HDMI", + .refresh = 60, + .xres = 1024, + .yres = 768, + .pixclock = 40385, + .left_margin = 220, + .right_margin = 40, + .upper_margin = 21, + .lower_margin = 7, + .hsync_len = 60, + .vsync_len = 10, + .sync = FB_SYNC_EXT, + .vmode = FB_VMODE_NONINTERLACED, + } + }, +}; +size_t display_count = ARRAY_SIZE(displays); + +static void cm_fx6_setup_display(void) +{ + struct mxc_ccm_reg *mxc_ccm = (struct mxc_ccm_reg *)CCM_BASE_ADDR; + int reg; + + enable_ipu_clock(); + imx_setup_hdmi(); + reg = __raw_readl(&mxc_ccm->CCGR3); + reg |= MXC_CCM_CCGR3_IPU1_IPU_DI0_MASK; + writel(reg, &mxc_ccm->CCGR3); +} +#else +static inline void cm_fx6_setup_display(void) {} +#endif /* CONFIG_VIDEO_IPUV3 */ + #ifdef CONFIG_DWC_AHSATA static int cm_fx6_issd_gpios[] = { /* The order of the GPIOs in the array is important! */ @@ -345,32 +412,36 @@ static iomux_v3_cfg_t const enet_pads[] = { MUX_PAD_CTRL(ENET_PAD_CTRL)), }; -static int handle_mac_address(void) +static int handle_mac_address(char *env_var, uint eeprom_bus) { unsigned char enetaddr[6]; int rc; - rc = eth_getenv_enetaddr("ethaddr", enetaddr); + rc = eth_getenv_enetaddr(env_var, enetaddr); if (rc) return 0; - rc = cl_eeprom_read_mac_addr(enetaddr); + rc = cl_eeprom_read_mac_addr(enetaddr, eeprom_bus); if (rc) return rc; if (!is_valid_ether_addr(enetaddr)) return -1; - return eth_setenv_enetaddr("ethaddr", enetaddr); + return eth_setenv_enetaddr(env_var, enetaddr); } +#define SB_FX6_I2C_EEPROM_BUS 0 +#define NO_MAC_ADDR "No MAC address found for %s\n" int board_eth_init(bd_t *bis) { int err; - err = handle_mac_address(); - if (err) - puts("No MAC address found\n"); + if (handle_mac_address("ethaddr", CONFIG_SYS_I2C_EEPROM_BUS)) + printf(NO_MAC_ADDR, "primary NIC"); + + if (handle_mac_address("eth1addr", SB_FX6_I2C_EEPROM_BUS)) + printf(NO_MAC_ADDR, "secondary NIC"); SETUP_IOMUX_PADS(enet_pads); /* phy reset */ @@ -464,7 +535,13 @@ int ft_board_setup(void *blob, bd_t *bd) /* MAC addr */ if (eth_getenv_enetaddr("ethaddr", enetaddr)) { - fdt_find_and_setprop(blob, "/fec", "local-mac-address", + fdt_find_and_setprop(blob, + "/soc/aips-bus@02100000/ethernet@02188000", + "local-mac-address", enetaddr, 6, 1); + } + + if (eth_getenv_enetaddr("eth1addr", enetaddr)) { + fdt_find_and_setprop(blob, "/eth@pcie", "local-mac-address", enetaddr, 6, 1); } @@ -506,6 +583,8 @@ int board_init(void) if (ret) printf("Warning: I2C setup failed: %d\n", ret); + cm_fx6_setup_display(); + return 0; } |
