diff options
Diffstat (limited to 'arch/arm/include/asm/arch-omap4')
-rw-r--r-- | arch/arm/include/asm/arch-omap4/omap.h | 36 | ||||
-rw-r--r-- | arch/arm/include/asm/arch-omap4/sys_proto.h | 12 |
2 files changed, 4 insertions, 44 deletions
diff --git a/arch/arm/include/asm/arch-omap4/omap.h b/arch/arm/include/asm/arch-omap4/omap.h index ad984da0b4..e9a6ffeb83 100644 --- a/arch/arm/include/asm/arch-omap4/omap.h +++ b/arch/arm/include/asm/arch-omap4/omap.h @@ -143,40 +143,4 @@ struct s32ktimer { #define NON_SECURE_SRAM_END 0x4030E000 /* Not inclusive */ /* base address for indirect vectors (internal boot mode) */ #define SRAM_ROM_VECT_BASE 0x4030D000 -/* Temporary SRAM stack used while low level init is done */ -#define SRAM_SCRATCH_SPACE_ADDR NON_SECURE_SRAM_START -/* SRAM scratch space entries */ -#define OMAP4_SRAM_SCRATCH_OMAP4_REV SRAM_SCRATCH_SPACE_ADDR -#define OMAP4_SRAM_SCRATCH_EMIF_T_NUM (SRAM_SCRATCH_SPACE_ADDR + 0xC) -#define OMAP4_SRAM_SCRATCH_EMIF_T_DEN (SRAM_SCRATCH_SPACE_ADDR + 0x10) -#define OMAP_SRAM_SCRATCH_PRCM_PTR (SRAM_SCRATCH_SPACE_ADDR + 0x14) -#define OMAP_SRAM_SCRATCH_DPLLS_PTR (SRAM_SCRATCH_SPACE_ADDR + 0x18) -#define OMAP_SRAM_SCRATCH_VCORES_PTR (SRAM_SCRATCH_SPACE_ADDR + 0x1C) -#define OMAP4_SRAM_SCRATCH_SYS_CTRL (SRAM_SCRATCH_SPACE_ADDR + 0x20) -#define OMAP4_SRAM_SCRATCH_SPACE_END (SRAM_SCRATCH_SPACE_ADDR + 0x24) - -/* ROM code defines */ -/* Boot device */ -#define BOOT_DEVICE_MASK 0xFF -#define BOOT_DEVICE_OFFSET 0x8 -#define DEV_DESC_PTR_OFFSET 0x4 -#define DEV_DATA_PTR_OFFSET 0x18 -#define BOOT_MODE_OFFSET 0x8 -#define RESET_REASON_OFFSET 0x9 -#define CH_FLAGS_OFFSET 0xA - -#define CH_FLAGS_CHSETTINGS (0x1 << 0) -#define CH_FLAGS_CHRAM (0x1 << 1) -#define CH_FLAGS_CHFLASH (0x1 << 2) -#define CH_FLAGS_CHMMCSD (0x1 << 3) - -#ifndef __ASSEMBLY__ -struct omap_boot_parameters { - char *boot_message; - unsigned int mem_boot_descriptor; - unsigned char omap_bootdevice; - unsigned char reset_reason; - unsigned char ch_flags; -}; -#endif #endif diff --git a/arch/arm/include/asm/arch-omap4/sys_proto.h b/arch/arm/include/asm/arch-omap4/sys_proto.h index d5f1868eee..039a1f2604 100644 --- a/arch/arm/include/asm/arch-omap4/sys_proto.h +++ b/arch/arm/include/asm/arch-omap4/sys_proto.h @@ -27,6 +27,8 @@ #include <asm/omap_common.h> #include <asm/arch/mux_omap4.h> +DECLARE_GLOBAL_DATA_PTR; + struct omap_sysinfo { char *board_string; }; @@ -58,13 +60,7 @@ void omap_vc_init(u16 speed_khz); int omap_vc_bypass_send_value(u8 sa, u8 reg_addr, u8 reg_data); u32 warm_reset(void); void force_emif_self_refresh(void); -/* - * This is used to verify if the configuration header - * was executed by Romcode prior to control of transfer - * to the bootloader. SPL is responsible for saving and - * passing this to the u-boot. - */ -extern struct omap_boot_parameters boot_params; +void setup_warmreset_time(void); static inline u32 running_from_sdram(void) { @@ -84,7 +80,7 @@ static inline u8 uboot_loaded_by_spl(void) * variable by both SPL and u-boot.Check out for CHSETTINGS, which is a * mandatory section if CH is present. */ - if ((boot_params.ch_flags) & (CH_FLAGS_CHSETTINGS)) + if ((gd->arch.omap_boot_params.ch_flags) & (CH_FLAGS_CHSETTINGS)) return 0; else return running_from_sdram(); |