diff options
| -rw-r--r-- | arch/arm/cpu/armv7/uniphier/Kconfig | 11 | ||||
| -rw-r--r-- | arch/arm/cpu/armv7/uniphier/Makefile | 24 | ||||
| -rw-r--r-- | arch/arm/cpu/armv7/uniphier/ph1-ld4/Makefile | 13 | ||||
| -rw-r--r-- | arch/arm/cpu/armv7/uniphier/ph1-pro4/Makefile | 12 | ||||
| -rw-r--r-- | arch/arm/cpu/armv7/uniphier/ph1-sld8/Makefile | 13 |
5 files changed, 41 insertions, 32 deletions
diff --git a/arch/arm/cpu/armv7/uniphier/Kconfig b/arch/arm/cpu/armv7/uniphier/Kconfig index 0556e4b350..5c5a84fe56 100644 --- a/arch/arm/cpu/armv7/uniphier/Kconfig +++ b/arch/arm/cpu/armv7/uniphier/Kconfig @@ -50,21 +50,12 @@ endchoice config CMD_PINMON bool "Enable boot mode pins monitor command" - depends on !SPL_BUILD default y help The command "pinmon" shows the state of the boot mode pins. The boot mode pins are latched when the system reset is deasserted and determine which device the system should load a boot image from. -config SOC_INIT - bool - default SPL_BUILD - -config DRAM_INIT - bool - default SPL_BUILD - config CMD_DDRPHY_DUMP bool "Enable dump command of DDR PHY parameters" depends on !SPL_BUILD @@ -74,7 +65,7 @@ config CMD_DDRPHY_DUMP choice prompt "DDR3 Frequency select" - depends on DRAM_INIT + depends on SPL_BUILD config DDR_FREQ_1600 bool "DDR3 1600" diff --git a/arch/arm/cpu/armv7/uniphier/Makefile b/arch/arm/cpu/armv7/uniphier/Makefile index 713a0d74ed..df418dd3c4 100644 --- a/arch/arm/cpu/armv7/uniphier/Makefile +++ b/arch/arm/cpu/armv7/uniphier/Makefile @@ -2,24 +2,32 @@ # SPDX-License-Identifier: GPL-2.0+ # -obj-$(CONFIG_SPL_BUILD) += lowlevel_init.o init_page_table.o -obj-$(CONFIG_SPL_BUILD) += spl.o +ifdef CONFIG_SPL_BUILD + +obj-y += lowlevel_init.o +obj-y += init_page_table.o +obj-y += spl.o +obj-y += ddrphy_training.o + +else -obj-y += timer.o -obj-y += reset.o -obj-y += cache_uniphier.o -obj-y += dram_init.o -obj-$(CONFIG_DRAM_INIT) += ddrphy_training.o obj-$(CONFIG_BOARD_EARLY_INIT_F) += board_early_init_f.o obj-$(CONFIG_DISPLAY_CPUINFO) += cpu_info.o obj-$(CONFIG_MISC_INIT_F) += print_misc_info.o +obj-y += dram_init.o +obj-y += board_common.o obj-$(CONFIG_BOARD_EARLY_INIT_R) += board_early_init_r.o obj-$(CONFIG_BOARD_LATE_INIT) += board_late_init.o +obj-y += reset.o +obj-y += cache_uniphier.o obj-$(CONFIG_UNIPHIER_SMP) += smp.o obj-$(CONFIG_CMD_PINMON) += cmd_pinmon.o obj-$(CONFIG_CMD_DDRPHY_DUMP) += cmd_ddrphy.o -obj-y += board_common.o +endif + +obj-y += timer.o + obj-$(CONFIG_PFC_MICRO_SUPPORT_CARD) += support_card.o obj-$(CONFIG_DCC_MICRO_SUPPORT_CARD) += support_card.o diff --git a/arch/arm/cpu/armv7/uniphier/ph1-ld4/Makefile b/arch/arm/cpu/armv7/uniphier/ph1-ld4/Makefile index bef1b8ae91..72f46636fd 100644 --- a/arch/arm/cpu/armv7/uniphier/ph1-ld4/Makefile +++ b/arch/arm/cpu/armv7/uniphier/ph1-ld4/Makefile @@ -2,10 +2,13 @@ # SPDX-License-Identifier: GPL-2.0+ # -obj-$(if $(CONFIG_OF_CONTROL),,y) += platdevice.o -obj-y += boot-mode.o +ifdef CONFIG_SPL_BUILD obj-$(CONFIG_DEBUG_LL) += lowlevel_debug.o -obj-$(CONFIG_SOC_INIT) += bcu_init.o sbc_init.o sg_init.o pll_init.o \ - clkrst_init.o +obj-y += bcu_init.o sbc_init.o sg_init.o pll_init.o clkrst_init.o \ + pll_spectrum.o umc_init.o ddrphy_init.o +else obj-$(CONFIG_BOARD_EARLY_INIT_F) += pinctrl.o -obj-$(CONFIG_DRAM_INIT) += pll_spectrum.o umc_init.o ddrphy_init.o +obj-$(if $(CONFIG_OF_CONTROL),,y) += platdevice.o +endif + +obj-y += boot-mode.o diff --git a/arch/arm/cpu/armv7/uniphier/ph1-pro4/Makefile b/arch/arm/cpu/armv7/uniphier/ph1-pro4/Makefile index 484e978e2d..e330fda1ed 100644 --- a/arch/arm/cpu/armv7/uniphier/ph1-pro4/Makefile +++ b/arch/arm/cpu/armv7/uniphier/ph1-pro4/Makefile @@ -2,9 +2,13 @@ # SPDX-License-Identifier: GPL-2.0+ # -obj-$(if $(CONFIG_OF_CONTROL),,y) += platdevice.o -obj-y += boot-mode.o +ifdef CONFIG_SPL_BUILD obj-$(CONFIG_DEBUG_LL) += lowlevel_debug.o -obj-$(CONFIG_SOC_INIT) += sbc_init.o sg_init.o pll_init.o clkrst_init.o +obj-y += sbc_init.o sg_init.o pll_init.o clkrst_init.o \ + pll_spectrum.o umc_init.o ddrphy_init.o +else obj-$(CONFIG_BOARD_EARLY_INIT_F) += pinctrl.o -obj-$(CONFIG_DRAM_INIT) += pll_spectrum.o umc_init.o ddrphy_init.o +obj-$(if $(CONFIG_OF_CONTROL),,y) += platdevice.o +endif + +obj-y += boot-mode.o diff --git a/arch/arm/cpu/armv7/uniphier/ph1-sld8/Makefile b/arch/arm/cpu/armv7/uniphier/ph1-sld8/Makefile index bef1b8ae91..72f46636fd 100644 --- a/arch/arm/cpu/armv7/uniphier/ph1-sld8/Makefile +++ b/arch/arm/cpu/armv7/uniphier/ph1-sld8/Makefile @@ -2,10 +2,13 @@ # SPDX-License-Identifier: GPL-2.0+ # -obj-$(if $(CONFIG_OF_CONTROL),,y) += platdevice.o -obj-y += boot-mode.o +ifdef CONFIG_SPL_BUILD obj-$(CONFIG_DEBUG_LL) += lowlevel_debug.o -obj-$(CONFIG_SOC_INIT) += bcu_init.o sbc_init.o sg_init.o pll_init.o \ - clkrst_init.o +obj-y += bcu_init.o sbc_init.o sg_init.o pll_init.o clkrst_init.o \ + pll_spectrum.o umc_init.o ddrphy_init.o +else obj-$(CONFIG_BOARD_EARLY_INIT_F) += pinctrl.o -obj-$(CONFIG_DRAM_INIT) += pll_spectrum.o umc_init.o ddrphy_init.o +obj-$(if $(CONFIG_OF_CONTROL),,y) += platdevice.o +endif + +obj-y += boot-mode.o |
