1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
|
UniPhier GPIO controller
Required properties:
- compatible: Should be "socionext,uniphier-gpio".
- reg: Specifies offset and length of the register set for the device.
- gpio-controller: Marks the device node as a GPIO controller.
- #gpio-cells: Should be 2. The first cell is the pin number and the second
cell is used to specify optional parameters.
- interrupt-parent: Specifies the parent interrupt controller.
- interrupt-controller: Marks the device node as an interrupt controller.
- #interrupt-cells: Should be 2. The first cell defines the interrupt number.
The second cell bits[3:0] is used to specify trigger type as follows:
1 = low-to-high edge triggered
2 = high-to-low edge triggered
4 = active high level-sensitive
8 = active low level-sensitive
Valid combinations are 1, 2, 3, 4, 8.
- ngpios: Specifies the number of GPIO lines.
- gpio-ranges: Mapping to pin controller pins (as described in gpio.txt)
- socionext,interrupt-ranges: Specifies an interrupt number mapping between
this GPIO controller and its interrupt parent, in the form of arbitrary
number of <child-interrupt-base parent-interrupt-base length> triplets.
Optional properties:
- gpio-ranges-group-names: Used for named gpio ranges (as described in gpio.txt)
Example:
gpio: gpio@55000000 {
compatible = "socionext,uniphier-gpio";
reg = <0x55000000 0x200>;
interrupt-parent = <&aidet>;
interrupt-controller;
#interrupt-cells = <2>;
gpio-controller;
#gpio-cells = <2>;
gpio-ranges = <&pinctrl 0 0 0>;
gpio-ranges-group-names = "gpio_range";
ngpios = <248>;
socionext,interrupt-ranges = <0 48 16>, <16 154 5>, <21 217 3>;
};
Consumer Example:
sdhci0_pwrseq {
compatible = "mmc-pwrseq-emmc";
reset-gpios = <&gpio UNIPHIER_GPIO_PORT(29, 4) GPIO_ACTIVE_LOW>;
};
Please note UNIPHIER_GPIO_PORT(29, 4) represents PORT294 in the SoC document.
Unfortunately, only the one's place is octal in the port numbering. (That is,
PORT 8, 9, 18, 19, 28, 29, ... are missing.) UNIPHIER_GPIO_PORT() is a helper
macro to calculate 29 * 8 + 4.
|
