blob: 14f52d70621b6a89606b9524512d8a1a7c4f1b23 (
plain)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
|
What: /sys/bus/usb/devices/<busnum>-<devnum>:<config num>.<interface num>/<hid-bus>:<vendor-id>:<product-id>.<num>/operation_mode
Date: March 2010
Contact: Bruno Prémont <bonbons@linux-vserver.org>
Description: Make it possible to switch the PicoLCD device between LCD
(firmware) and bootloader (flasher) operation modes.
Reading: returns list of available modes, the active mode being
enclosed in brackets ('[' and ']')
Writing: causes operation mode switch. Permitted values are
the non-active mode names listed when read, optionally followed
by a delay value expressed in ms.
Note: when switching mode the current PicoLCD HID device gets
disconnected and reconnects after above delay (default value
is 5 seconds though this default should not be relied on).
What: /sys/bus/usb/devices/<busnum>-<devnum>:<config num>.<interface num>/<hid-bus>:<vendor-id>:<product-id>.<num>/fb_update_rate
Date: March 2010
Contact: Bruno Prémont <bonbons@linux-vserver.org>
Description: Make it possible to adjust defio refresh rate.
Reading: returns list of available refresh rates (expressed in Hz),
the active refresh rate being enclosed in brackets ('[' and ']')
Writing: accepts new refresh rate expressed in integer Hz
within permitted rates.
Note: As device can barely do 2 complete refreshes a second
it only makes sense to adjust this value if only one or two
tiles get changed and it's not appropriate to expect the application
to flush it's tiny changes explicitely at higher than default rate.
|
