blob: 87740adb299560e44aec9966c9c88b33db3657ba (
plain)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
|
NXP LPC18xx/43xx DMA MUX (DMA request router)
Required properties:
- compatible: "nxp,lpc1850-dmamux"
- reg: Memory map for accessing module
- #dma-cells: Should be set to <3>.
* 1st cell contain the master dma request signal
* 2nd cell contain the mux value (0-3) for the peripheral
* 3rd cell contain either 1 or 2 depending on the AHB
master used.
- dma-requests: Number of DMA requests for the mux
- dma-masters: phandle pointing to the DMA controller
The DMA controller node need to have the following poroperties:
- dma-requests: Number of DMA requests the controller can handle
Example:
dmac: dma@40002000 {
compatible = "nxp,lpc1850-gpdma", "arm,pl080", "arm,primecell";
arm,primecell-periphid = <0x00041080>;
reg = <0x40002000 0x1000>;
interrupts = <2>;
clocks = <&ccu1 CLK_CPU_DMA>;
clock-names = "apb_pclk";
#dma-cells = <2>;
dma-channels = <8>;
dma-requests = <16>;
lli-bus-interface-ahb1;
lli-bus-interface-ahb2;
mem-bus-interface-ahb1;
mem-bus-interface-ahb2;
memcpy-burst-size = <256>;
memcpy-bus-width = <32>;
};
dmamux: dma-mux {
compatible = "nxp,lpc1850-dmamux";
#dma-cells = <3>;
dma-requests = <64>;
dma-masters = <&dmac>;
};
uart0: serial@40081000 {
compatible = "nxp,lpc1850-uart", "ns16550a";
reg = <0x40081000 0x1000>;
reg-shift = <2>;
interrupts = <24>;
clocks = <&ccu2 CLK_APB0_UART0>, <&ccu1 CLK_CPU_UART0>;
clock-names = "uartclk", "reg";
dmas = <&dmamux 1 1 2
&dmamux 2 1 2>;
dma-names = "tx", "rx";
};
|
