diff options
Diffstat (limited to 'Documentation/kernel-parameters.txt')
| -rw-r--r-- | Documentation/kernel-parameters.txt | 18 |
1 files changed, 16 insertions, 2 deletions
diff --git a/Documentation/kernel-parameters.txt b/Documentation/kernel-parameters.txt index 74339c57b914..479f33204a37 100644 --- a/Documentation/kernel-parameters.txt +++ b/Documentation/kernel-parameters.txt @@ -1264,7 +1264,7 @@ bytes respectively. Such letter suffixes can also be entirely omitted. i8042.noloop [HW] Disable the AUX Loopback command while probing for the AUX port i8042.nomux [HW] Don't check presence of an active multiplexing - controller. Default: true. + controller i8042.nopnp [HW] Don't use ACPIPnP / PnPBIOS to discover KBD/AUX controllers i8042.notimeout [HW] Ignore timeout condition signalled by controller @@ -1307,6 +1307,18 @@ bytes respectively. Such letter suffixes can also be entirely omitted. .cdrom .chs .ignore_cable are additional options See Documentation/ide/ide.txt. + ide-generic.probe-mask= [HW] (E)IDE subsystem + Format: <int> + Probe mask for legacy ISA IDE ports. Depending on + platform up to 6 ports are supported, enabled by + setting corresponding bits in the mask to 1. The + default value is 0x0, which has a special meaning. + On systems that have PCI, it triggers scanning the + PCI bus for the first and the second port, which + are then probed. On systems without PCI the value + of 0x0 enables probing the two first ports as if it + was 0x3. + ide-pci-generic.all-generic-ide [HW] (E)IDE subsystem Claim all unknown PCI IDE storage controllers. @@ -1587,6 +1599,8 @@ bytes respectively. Such letter suffixes can also be entirely omitted. kmemleak= [KNL] Boot-time kmemleak enable/disable Valid arguments: on, off Default: on + Built with CONFIG_DEBUG_KMEMLEAK_DEFAULT_OFF=y, + the default is off. kmemcheck= [X86] Boot-time kmemcheck enable/disable/one-shot mode Valid arguments: 0, 1, 2 @@ -3607,7 +3621,7 @@ bytes respectively. Such letter suffixes can also be entirely omitted. usb-storage.delay_use= [UMS] The delay in seconds before a new device is - scanned for Logical Units (default 5). + scanned for Logical Units (default 1). usb-storage.quirks= [UMS] A list of quirks entries to supplement or |
