diff options
Diffstat (limited to 'drivers')
| -rw-r--r-- | drivers/gpio/pca953x.c | 2 | ||||
| -rw-r--r-- | drivers/misc/ds4510.c | 8 | ||||
| -rw-r--r-- | drivers/qe/qe.c | 5 |
3 files changed, 9 insertions, 6 deletions
diff --git a/drivers/gpio/pca953x.c b/drivers/gpio/pca953x.c index 1c5e314d9d..e8273ee363 100644 --- a/drivers/gpio/pca953x.c +++ b/drivers/gpio/pca953x.c @@ -221,7 +221,7 @@ U_BOOT_CMD( "pca953x invert pin 0|1\n" " - disable/enable polarity inversion for reads\n" "pca953x intput pin\n" - " - set pin as input and read value\n" + " - set pin as input and read value" ); #endif /* CONFIG_CMD_PCA953X */ diff --git a/drivers/misc/ds4510.c b/drivers/misc/ds4510.c index 8b5fbbc456..f2510a38fd 100644 --- a/drivers/misc/ds4510.c +++ b/drivers/misc/ds4510.c @@ -404,12 +404,14 @@ U_BOOT_CMD( "ds4510 pullup pin 0|1\n" " - disable/enable pullup on specified pin\n" "ds4510 nv 0|1\n" - " - make gpio and seeprom writes volatile/non-volatile\n" + " - make gpio and seeprom writes volatile/non-volatile" #ifdef CONFIG_CMD_DS4510_RST + "\n" "ds4510 rstdelay 0-3\n" - " - set reset output delay\n" + " - set reset output delay" #endif #ifdef CONFIG_CMD_DS4510_MEM + "\n" "ds4510 eeprom read addr off cnt\n" "ds4510 eeprom write addr off cnt\n" " - read/write 'cnt' bytes at EEPROM offset 'off'\n" @@ -418,7 +420,7 @@ U_BOOT_CMD( " - read/write 'cnt' bytes at SRAM-shadowed EEPROM offset 'off'\n" "ds4510 sram read addr off cnt\n" "ds4510 sram write addr off cnt\n" - " - read/write 'cnt' bytes at SRAM offset 'off'\n" + " - read/write 'cnt' bytes at SRAM offset 'off'" #endif ); #endif /* CONFIG_CMD_DS4510 */ diff --git a/drivers/qe/qe.c b/drivers/qe/qe.c index f114fe06a4..918bfa748e 100644 --- a/drivers/qe/qe.c +++ b/drivers/qe/qe.c @@ -473,5 +473,6 @@ U_BOOT_CMD( qe, 4, 0, qe_cmd, "QUICC Engine commands", "fw <addr> [<length>] - Upload firmware binary at address <addr> to " - "the QE,\n\twith optional length <length> verification.\n" - ); + "the QE,\n" + "\twith optional length <length> verification." +); |
