diff options
Diffstat (limited to 'drivers/net/fec_mxc.c')
| -rw-r--r-- | drivers/net/fec_mxc.c | 164 |
1 files changed, 90 insertions, 74 deletions
diff --git a/drivers/net/fec_mxc.c b/drivers/net/fec_mxc.c index 3e232c7cbc..4dbcdca4a0 100644 --- a/drivers/net/fec_mxc.c +++ b/drivers/net/fec_mxc.c @@ -135,15 +135,15 @@ static int fec_mdio_read(struct ethernet_regs *eth, uint8_t phyAddr, return val; } -static void fec_mii_setspeed(struct fec_priv *fec) +static void fec_mii_setspeed(struct ethernet_regs *eth) { /* * Set MII_SPEED = (1/(mii_speed * 2)) * System Clock * and do not drop the Preamble. */ writel((((imx_get_fecclk() / 1000000) + 2) / 5) << 1, - &fec->eth->mii_speed); - debug("%s: mii_speed %08x\n", __func__, readl(&fec->eth->mii_speed)); + ð->mii_speed); + debug("%s: mii_speed %08x\n", __func__, readl(ð->mii_speed)); } static int fec_mdio_write(struct ethernet_regs *eth, uint8_t phyAddr, @@ -392,21 +392,6 @@ static int fec_set_hwaddr(struct eth_device *dev) return 0; } -static void fec_eth_phy_config(struct eth_device *dev) -{ -#ifdef CONFIG_PHYLIB - struct fec_priv *fec = (struct fec_priv *)dev->priv; - struct phy_device *phydev; - - phydev = phy_connect(fec->bus, fec->phy_id, dev, - PHY_INTERFACE_MODE_RGMII); - if (phydev) { - fec->phydev = phydev; - phy_config(phydev); - } -#endif -} - /* * Do initial configuration of the FEC registers */ @@ -511,9 +496,7 @@ static int fec_open(struct eth_device *edev) #endif #ifdef CONFIG_PHYLIB - if (!fec->phydev) - fec_eth_phy_config(edev); - if (fec->phydev) { + { /* Start up the PHY */ int ret = phy_startup(fec->phydev); @@ -523,8 +506,6 @@ static int fec_open(struct eth_device *edev) return ret; } speed = fec->phydev->speed; - } else { - speed = _100BASET; } #else miiphy_wait_aneg(edev); @@ -611,7 +592,7 @@ static int fec_init(struct eth_device *dev, bd_t* bd) fec_reg_setup(fec); if (fec->xcv_type != SEVENWIRE) - fec_mii_setspeed(fec); + fec_mii_setspeed(fec->bus->priv); /* * Set Opcode/Pause Duration Register @@ -915,11 +896,21 @@ static int fec_recv(struct eth_device *dev) return len; } -static int fec_probe(bd_t *bd, int dev_id, int phy_id, uint32_t base_addr) +static void fec_set_dev_name(char *dest, int dev_id) +{ + sprintf(dest, (dev_id == -1) ? "FEC" : "FEC%i", dev_id); +} + +#ifdef CONFIG_PHYLIB +int fec_probe(bd_t *bd, int dev_id, uint32_t base_addr, + struct mii_dev *bus, struct phy_device *phydev) +#else +static int fec_probe(bd_t *bd, int dev_id, uint32_t base_addr, + struct mii_dev *bus, int phy_id) +#endif { struct eth_device *edev; struct fec_priv *fec; - struct mii_dev *bus; unsigned char ethaddr[6]; uint32_t start; int ret = 0; @@ -966,53 +957,25 @@ static int fec_probe(bd_t *bd, int dev_id, int phy_id, uint32_t base_addr) } fec_reg_setup(fec); - fec_mii_setspeed(fec); - - if (dev_id == -1) { - sprintf(edev->name, "FEC"); - fec->dev_id = 0; - } else { - sprintf(edev->name, "FEC%i", dev_id); - fec->dev_id = dev_id; - } - fec->phy_id = phy_id; - - bus = mdio_alloc(); - if (!bus) { - printf("mdio_alloc failed\n"); - ret = -ENOMEM; - goto err3; - } - bus->read = fec_phy_read; - bus->write = fec_phy_write; - sprintf(bus->name, edev->name); -#ifdef CONFIG_MX28 - /* - * The i.MX28 has two ethernet interfaces, but they are not equal. - * Only the first one can access the MDIO bus. - */ - bus->priv = (struct ethernet_regs *)MXS_ENET0_BASE; + fec_set_dev_name(edev->name, dev_id); + fec->dev_id = (dev_id == -1) ? 0 : dev_id; + fec->bus = bus; + fec_mii_setspeed(bus->priv); +#ifdef CONFIG_PHYLIB + fec->phydev = phydev; + phy_connect_dev(phydev, edev); + /* Configure phy */ + phy_config(phydev); #else - bus->priv = fec->eth; + fec->phy_id = phy_id; #endif - ret = mdio_register(bus); - if (ret) { - printf("mdio_register failed\n"); - free(bus); - ret = -ENOMEM; - goto err3; - } - fec->bus = bus; eth_register(edev); if (fec_get_hwaddr(edev, dev_id, ethaddr) == 0) { debug("got MAC%d address from fuse: %pM\n", dev_id, ethaddr); memcpy(edev->enetaddr, ethaddr, 6); } - /* Configure phy */ - fec_eth_phy_config(edev); return ret; - err3: free(fec); err2: @@ -1021,27 +984,80 @@ err1: return ret; } -#ifndef CONFIG_FEC_MXC_MULTI -int fecmxc_initialize(bd_t *bd) +struct mii_dev *fec_get_miibus(uint32_t base_addr, int dev_id) { - int lout = 1; + struct ethernet_regs *eth = (struct ethernet_regs *)base_addr; + struct mii_dev *bus; + int ret; - debug("eth_init: fec_probe(bd)\n"); - lout = fec_probe(bd, -1, CONFIG_FEC_MXC_PHYADDR, IMX_FEC_BASE); + bus = mdio_alloc(); + if (!bus) { + printf("mdio_alloc failed\n"); + return NULL; + } + bus->read = fec_phy_read; + bus->write = fec_phy_write; + bus->priv = eth; + fec_set_dev_name(bus->name, dev_id); - return lout; + ret = mdio_register(bus); + if (ret) { + printf("mdio_register failed\n"); + free(bus); + return NULL; + } + fec_mii_setspeed(eth); + return bus; } -#endif int fecmxc_initialize_multi(bd_t *bd, int dev_id, int phy_id, uint32_t addr) { - int lout = 1; + uint32_t base_mii; + struct mii_dev *bus = NULL; +#ifdef CONFIG_PHYLIB + struct phy_device *phydev = NULL; +#endif + int ret; +#ifdef CONFIG_MX28 + /* + * The i.MX28 has two ethernet interfaces, but they are not equal. + * Only the first one can access the MDIO bus. + */ + base_mii = MXS_ENET0_BASE; +#else + base_mii = addr; +#endif debug("eth_init: fec_probe(bd, %i, %i) @ %08x\n", dev_id, phy_id, addr); - lout = fec_probe(bd, dev_id, phy_id, addr); + bus = fec_get_miibus(base_mii, dev_id); + if (!bus) + return -ENOMEM; +#ifdef CONFIG_PHYLIB + phydev = phy_find_by_mask(bus, 1 << phy_id, PHY_INTERFACE_MODE_RGMII); + if (!phydev) { + free(bus); + return -ENOMEM; + } + ret = fec_probe(bd, dev_id, addr, bus, phydev); +#else + ret = fec_probe(bd, dev_id, addr, bus, phy_id); +#endif + if (ret) { +#ifdef CONFIG_PHYLIB + free(phydev); +#endif + free(bus); + } + return ret; +} - return lout; +#ifdef CONFIG_FEC_MXC_PHYADDR +int fecmxc_initialize(bd_t *bd) +{ + return fecmxc_initialize_multi(bd, -1, CONFIG_FEC_MXC_PHYADDR, + IMX_FEC_BASE); } +#endif #ifndef CONFIG_PHYLIB int fecmxc_register_mii_postcall(struct eth_device *dev, int (*cb)(int)) |
