diff options
Diffstat (limited to 'drivers/i2c/mvtwsi.c')
| -rw-r--r-- | drivers/i2c/mvtwsi.c | 28 |
1 files changed, 5 insertions, 23 deletions
diff --git a/drivers/i2c/mvtwsi.c b/drivers/i2c/mvtwsi.c index 90c8387918..5ba0e03862 100644 --- a/drivers/i2c/mvtwsi.c +++ b/drivers/i2c/mvtwsi.c @@ -216,21 +216,7 @@ static int twsi_stop(int status) */ #define TWSI_FREQUENCY(m, n) \ - ((u8) (CONFIG_SYS_TCLK / (10 * (m + 1) * 2 * (1 << n)))) - -/* - * These are required to be reprogrammed before enabling the controller - * because a reset loses them. - * Default values come from the spec, but a twsi_reset will change them. - * twsi_slave_address left uninitialized lest checkpatch.pl complains. - */ - -/* Baudrate generator: m (bits 7..4) =4, n (bits 3..0) =4 */ -static u8 twsi_baud_rate = 0x44; /* baudrate at controller reset */ -/* Default frequency corresponding to default m=4, n=4 */ -static u8 twsi_actual_speed = TWSI_FREQUENCY(4, 4); -/* Default slave address is 0 (so is an uninitialized static) */ -static u8 twsi_slave_address; + (CONFIG_SYS_TCLK / (10 * (m + 1) * (1 << n))) /* * Reset controller. @@ -238,7 +224,7 @@ static u8 twsi_slave_address; * Controller reset also resets the baud rate and slave address, so * re-establish them. */ -static void twsi_reset(void) +static void twsi_reset(u8 baud_rate, u8 slave_address) { /* ensure controller will be enabled by any twsi*() function */ twsi_control_flags = MVTWSI_CONTROL_TWSIEN; @@ -247,9 +233,9 @@ static void twsi_reset(void) /* wait 2 ms -- this is what the Marvell LSP does */ udelay(20000); /* set baud rate */ - writel(twsi_baud_rate, &twsi->baudrate); + writel(baud_rate, &twsi->baudrate); /* set slave address even though we don't use it */ - writel(twsi_slave_address, &twsi->slave_address); + writel(slave_address, &twsi->slave_address); writel(0, &twsi->xtnd_slave_addr); /* assert STOP but don't care for the result */ (void) twsi_stop(0); @@ -277,12 +263,8 @@ void i2c_init(int requested_speed, int slaveadd) } } } - /* save baud rate and slave for later calls to twsi_reset */ - twsi_baud_rate = baud; - twsi_actual_speed = highest_speed; - twsi_slave_address = slaveadd; /* reset controller */ - twsi_reset(); + twsi_reset(baud, slaveadd); } /* |
