diff options
Diffstat (limited to 'board/solidrun/hummingboard/README')
| -rw-r--r-- | board/solidrun/hummingboard/README | 40 |
1 files changed, 0 insertions, 40 deletions
diff --git a/board/solidrun/hummingboard/README b/board/solidrun/hummingboard/README deleted file mode 100644 index cfd62d40be..0000000000 --- a/board/solidrun/hummingboard/README +++ /dev/null @@ -1,40 +0,0 @@ -U-Boot for SolidRun Hummingboard --------------------------------- - -This file contains information for the port of U-Boot to the Hummingboard. - -For more details about Hummingboard, please refer to: -http://imx.solid-run.com/wiki/index.php?title=Carrier-One_Hardware - -(Carrier-One was the previous name of Hummingboard). - -Building U-boot for Hummingboard --------------------------------- - -To build U-Boot for the Hummingboard Solo version: - -$ make hummingboard_solo_config -$ make - -Flashing U-boot into the SD card --------------------------------- - -- After the 'make' command completes, the generated 'u-boot.imx' binary must be -flashed into the SD card: - -$ sudo dd if=u-boot.imx of=/dev/mmcblk0 bs=1k seek=1; sync - -(Note - the SD card node may vary, so adjust this as needed). - -Also, a more detailed explanation on how to format the SD card is available -at doc/README.imximage. - -- Insert the micro SD card into the slot located in the bottom of the board - -- Connect a 3.3V USB to serial converter cable to the host PC. The MX6 UART -signals are available in the 26 pin connector as shown at: -http://imx.solid-run.com/wiki/index.php?title=Carrier-One_Hardware -(Check for "26 pin header layout"). - -- Power up the board via USB cable (CON201) and U-boot messages will appear in -the serial console. |
