1 files changed, 7 insertions, 103 deletions

diff --git a/board/esd/pmc405/pmc405.c b/board/esd/pmc405/pmc405.c
index 5c2e98c57e..5410a56c53 100644
--- a/board/esd/pmc405/pmc405.c
+++ b/board/esd/pmc405/pmc405.c
@@ -26,11 +26,13 @@
 #include <command.h>
 #include <malloc.h>
 
-/* ------------------------------------------------------------------------- */
-
 
-/* Prototypes */
-int gunzip(void *, int, unsigned char *, int *);
+/* fpga configuration data - not compressed, generated by bin2c */
+const unsigned char fpgadata[] =
+{
+#include "fpgadata.c"
+};
+int filesize = sizeof(fpgadata);
 
 
 int board_pre_init (void)
@@ -74,104 +76,6 @@ int misc_init_f (void)
 
 int misc_init_r (void)
 {
-#if 0 /* test-only */
-	DECLARE_GLOBAL_DATA_PTR;
-	volatile unsigned short *fpga_mode =
-		(unsigned short *)((ulong)CFG_FPGA_BASE_ADDR + CFG_FPGA_CTRL);
-	volatile unsigned char *duart0_mcr =
-		(unsigned char *)((ulong)DUART0_BA + 4);
-	volatile unsigned char *duart1_mcr =
-		(unsigned char *)((ulong)DUART1_BA + 4);
-	bd_t *bd = gd->bd;
-	char *	tmp;                    /* Temporary char pointer      */
-	unsigned char *dst;
-	ulong len = sizeof(fpgadata);
-	int status;
-	int index;
-	int i;
-	unsigned long cntrl0Reg;
-
-	/*
-	 * Setup GPIO pins (CS6+CS7 as GPIO)
-	 */
-	cntrl0Reg = mfdcr(cntrl0);
-	mtdcr(cntrl0, cntrl0Reg | 0x00300000);
-
-	dst = malloc(CFG_FPGA_MAX_SIZE);
-	if (gunzip (dst, CFG_FPGA_MAX_SIZE, (uchar *)fpgadata, (int *)&len) != 0) {
-		printf ("GUNZIP ERROR - must RESET board to recover\n");
-		do_reset (NULL, 0, 0, NULL);
-	}
-
-	status = fpga_boot(dst, len);
-	if (status != 0) {
-		printf("\nFPGA: Booting failed ");
-		switch (status) {
-		case ERROR_FPGA_PRG_INIT_LOW:
-			printf("(Timeout: INIT not low after asserting PROGRAM*)\n ");
-			break;
-		case ERROR_FPGA_PRG_INIT_HIGH:
-			printf("(Timeout: INIT not high after deasserting PROGRAM*)\n ");
-			break;
-		case ERROR_FPGA_PRG_DONE:
-			printf("(Timeout: DONE not high after programming FPGA)\n ");
-			break;
-		}
-
-		/* display infos on fpgaimage */
-		index = 15;
-		for (i=0; i<4; i++) {
-			len = dst[index];
-			printf("FPGA: %s\n", &(dst[index+1]));
-			index += len+3;
-		}
-		putc ('\n');
-		/* delayed reboot */
-		for (i=20; i>0; i--) {
-			printf("Rebooting in %2d seconds \r",i);
-			for (index=0;index<1000;index++)
-				udelay(1000);
-		}
-		putc ('\n');
-		do_reset(NULL, 0, 0, NULL);
-	}
-
-	/* restore gpio/cs settings */
-	mtdcr(cntrl0, cntrl0Reg);
-
-	puts("FPGA:  ");
-
-	/* display infos on fpgaimage */
-	index = 15;
-	for (i=0; i<4; i++) {
-		len = dst[index];
-		printf("%s ", &(dst[index+1]));
-		index += len+3;
-	}
-	putc ('\n');
-
-	free(dst);
-
-	/*
-	 * Reset FPGA via FPGA_DATA pin
-	 */
-	SET_FPGA(FPGA_PRG | FPGA_CLK);
-	udelay(1000); /* wait 1ms */
-	SET_FPGA(FPGA_PRG | FPGA_CLK | FPGA_DATA);
-	udelay(1000); /* wait 1ms */
-
-	/*
-	 * Enable power on PS/2 interface
-	 */
-	*fpga_mode |= CFG_FPGA_CTRL_PS2_RESET;
-
-	/*
-	 * Enable interrupts in exar duart mcr[3]
-	 */
-	*duart0_mcr = 0x08;
-	*duart1_mcr = 0x08;
-#endif
-
 	return (0);
 }
 
@@ -188,7 +92,7 @@ int checkboard (void)
 	puts ("Board: ");
 
 	if (i == -1) {
-		puts ("### No HW ID - assuming ABG405");
+		puts ("### No HW ID - assuming PMC405");
 	} else {
 		puts(str);
 	}