blob: 938f8e1ba2051c98302705df219da917b7e5952f (
plain)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
|
* EMIF family of TI SDRAM controllers
EMIF - External Memory Interface - is an SDRAM controller used in
TI SoCs. EMIF supports, based on the IP revision, one or more of
DDR2/DDR3/LPDDR2 protocols. This binding describes a given instance
of the EMIF IP and memory parts attached to it.
Required properties:
- compatible : Should be of the form "ti,emif-<ip-rev>" where <ip-rev>
is the IP revision of the specific EMIF instance.
- phy-type : <u32> indicating the DDR phy type. Following are the
allowed values
<1> : Attila PHY
<2> : Intelli PHY
- device-handle : phandle to a "lpddr2" node representing the memory part
- ti,hwmods : For TI hwmods processing and omap device creation
the value shall be "emif<n>" where <n> is the number of the EMIF
instance with base 1.
Optional properties:
- cs1-used : Have this property if CS1 of this EMIF
instance has a memory part attached to it. If there is a memory
part attached to CS1, it should be the same type as the one on CS0,
so there is no need to give the details of this memory part.
- cal-resistor-per-cs : Have this property if the board has one
calibration resistor per chip-select.
- hw-caps-read-idle-ctrl: Have this property if the controller
supports read idle window programming
- hw-caps-dll-calib-ctrl: Have this property if the controller
supports dll calibration control
- hw-caps-ll-interface : Have this property if the controller
has a low latency interface and corresponding interrupt events
- hw-caps-temp-alert : Have this property if the controller
has capability for generating SDRAM temperature alerts
Example:
emif1: emif@0x4c000000 {
compatible = "ti,emif-4d";
ti,hwmods = "emif2";
phy-type = <1>;
device-handle = <&elpida_ECB240ABACN>;
cs1-used;
hw-caps-read-idle-ctrl;
hw-caps-ll-interface;
hw-caps-temp-alert;
};
|
