diff options
Diffstat (limited to 'drivers')
| -rw-r--r-- | drivers/net/wireless/ath/ath9k/main.c | 156 | ||||
| -rw-r--r-- | drivers/net/wireless/ath/ath9k/pci.c | 21 |
2 files changed, 47 insertions, 130 deletions
diff --git a/drivers/net/wireless/ath/ath9k/main.c b/drivers/net/wireless/ath/ath9k/main.c index 3733828e72bc..8b0feecf3fae 100644 --- a/drivers/net/wireless/ath/ath9k/main.c +++ b/drivers/net/wireless/ath/ath9k/main.c @@ -887,82 +887,6 @@ chip_reset: #undef SCHED_INTR } -static void ath_radio_enable(struct ath_softc *sc, struct ieee80211_hw *hw) -{ - struct ath_hw *ah = sc->sc_ah; - struct ath_common *common = ath9k_hw_common(ah); - struct ieee80211_channel *channel = hw->conf.channel; - int r; - - ath9k_ps_wakeup(sc); - spin_lock_bh(&sc->sc_pcu_lock); - atomic_set(&ah->intr_ref_cnt, -1); - - ath9k_hw_configpcipowersave(ah, false); - - if (!ah->curchan) - ah->curchan = ath9k_cmn_get_curchannel(sc->hw, ah); - - r = ath9k_hw_reset(ah, ah->curchan, ah->caldata, false); - if (r) { - ath_err(common, - "Unable to reset channel (%u MHz), reset status %d\n", - channel->center_freq, r); - } - - ath_complete_reset(sc, true); - - /* Enable LED */ - ath9k_hw_cfg_output(ah, ah->led_pin, - AR_GPIO_OUTPUT_MUX_AS_OUTPUT); - ath9k_hw_set_gpio(ah, ah->led_pin, 0); - - spin_unlock_bh(&sc->sc_pcu_lock); - - ath9k_ps_restore(sc); -} - -void ath_radio_disable(struct ath_softc *sc, struct ieee80211_hw *hw) -{ - struct ath_hw *ah = sc->sc_ah; - struct ieee80211_channel *channel = hw->conf.channel; - int r; - - ath9k_ps_wakeup(sc); - - ath_cancel_work(sc); - - spin_lock_bh(&sc->sc_pcu_lock); - - /* - * Keep the LED on when the radio is disabled - * during idle unassociated state. - */ - if (!sc->ps_idle) { - ath9k_hw_set_gpio(ah, ah->led_pin, 1); - ath9k_hw_cfg_gpio_input(ah, ah->led_pin); - } - - ath_prepare_reset(sc, false, true); - - if (!ah->curchan) - ah->curchan = ath9k_cmn_get_curchannel(hw, ah); - - r = ath9k_hw_reset(ah, ah->curchan, ah->caldata, false); - if (r) { - ath_err(ath9k_hw_common(sc->sc_ah), - "Unable to reset channel (%u MHz), reset status %d\n", - channel->center_freq, r); - } - - ath9k_hw_phy_disable(ah); - - ath9k_hw_configpcipowersave(ah, true); - - spin_unlock_bh(&sc->sc_pcu_lock); - ath9k_ps_restore(sc); -} - static int ath_reset(struct ath_softc *sc, bool retry_tx) { int r; @@ -1098,6 +1022,9 @@ static int ath9k_start(struct ieee80211_hw *hw) * and then setup of the interrupt mask. */ spin_lock_bh(&sc->sc_pcu_lock); + + atomic_set(&ah->intr_ref_cnt, -1); + r = ath9k_hw_reset(ah, init_channel, ah->caldata, false); if (r) { ath_err(common, @@ -1139,6 +1066,18 @@ static int ath9k_start(struct ieee80211_hw *hw) goto mutex_unlock; } + if (ah->led_pin >= 0) { + ath9k_hw_cfg_output(ah, ah->led_pin, + AR_GPIO_OUTPUT_MUX_AS_OUTPUT); + ath9k_hw_set_gpio(ah, ah->led_pin, 0); + } + + /* + * Reset key cache to sane defaults (all entries cleared) instead of + * semi-random values after suspend/resume. + */ + ath9k_cmn_init_crypto(sc->sc_ah); + spin_unlock_bh(&sc->sc_pcu_lock); if ((ah->btcoex_hw.scheme != ATH_BTCOEX_CFG_NONE) && @@ -1237,6 +1176,7 @@ static void ath9k_stop(struct ieee80211_hw *hw) struct ath_softc *sc = hw->priv; struct ath_hw *ah = sc->sc_ah; struct ath_common *common = ath9k_hw_common(ah); + bool prev_idle; mutex_lock(&sc->mutex); @@ -1267,35 +1207,45 @@ static void ath9k_stop(struct ieee80211_hw *hw) * before setting the invalid flag. */ ath9k_hw_disable_interrupts(ah); - if (!(sc->sc_flags & SC_OP_INVALID)) { - ath_drain_all_txq(sc, false); - ath_stoprecv(sc); - ath9k_hw_phy_disable(ah); - } else - sc->rx.rxlink = NULL; + spin_unlock_bh(&sc->sc_pcu_lock); + + /* we can now sync irq and kill any running tasklets, since we already + * disabled interrupts and not holding a spin lock */ + synchronize_irq(sc->irq); + tasklet_kill(&sc->intr_tq); + tasklet_kill(&sc->bcon_tasklet); + + prev_idle = sc->ps_idle; + sc->ps_idle = true; + + spin_lock_bh(&sc->sc_pcu_lock); + + if (ah->led_pin >= 0) { + ath9k_hw_set_gpio(ah, ah->led_pin, 1); + ath9k_hw_cfg_gpio_input(ah, ah->led_pin); + } + + ath_prepare_reset(sc, false, true); if (sc->rx.frag) { dev_kfree_skb_any(sc->rx.frag); sc->rx.frag = NULL; } - /* disable HAL and put h/w to sleep */ - ath9k_hw_disable(ah); + if (!ah->curchan) + ah->curchan = ath9k_cmn_get_curchannel(hw, ah); - spin_unlock_bh(&sc->sc_pcu_lock); + ath9k_hw_reset(ah, ah->curchan, ah->caldata, false); + ath9k_hw_phy_disable(ah); - /* we can now sync irq and kill any running tasklets, since we already - * disabled interrupts and not holding a spin lock */ - synchronize_irq(sc->irq); - tasklet_kill(&sc->intr_tq); - tasklet_kill(&sc->bcon_tasklet); + ath9k_hw_configpcipowersave(ah, true); - ath9k_ps_restore(sc); + spin_unlock_bh(&sc->sc_pcu_lock); - sc->ps_idle = true; - ath_radio_disable(sc, hw); + ath9k_ps_restore(sc); sc->sc_flags |= SC_OP_INVALID; + sc->ps_idle = prev_idle; mutex_unlock(&sc->mutex); @@ -1635,8 +1585,8 @@ static int ath9k_config(struct ieee80211_hw *hw, u32 changed) struct ath_hw *ah = sc->sc_ah; struct ath_common *common = ath9k_hw_common(ah); struct ieee80211_conf *conf = &hw->conf; - bool disable_radio = false; + ath9k_ps_wakeup(sc); mutex_lock(&sc->mutex); /* @@ -1645,16 +1595,8 @@ static int ath9k_config(struct ieee80211_hw *hw, u32 changed) * of the changes. Likewise we must only disable the radio towards * the end. */ - if (changed & IEEE80211_CONF_CHANGE_IDLE) { + if (changed & IEEE80211_CONF_CHANGE_IDLE) sc->ps_idle = !!(conf->flags & IEEE80211_CONF_IDLE); - if (!sc->ps_idle) { - ath_radio_enable(sc, hw); - ath_dbg(common, ATH_DBG_CONFIG, - "not-idle: enabling radio\n"); - } else { - disable_radio = true; - } - } /* * We just prepare to enable PS. We have to wait until our AP has @@ -1760,18 +1702,12 @@ static int ath9k_config(struct ieee80211_hw *hw, u32 changed) ath_dbg(common, ATH_DBG_CONFIG, "Set power: %d\n", conf->power_level); sc->config.txpowlimit = 2 * conf->power_level; - ath9k_ps_wakeup(sc); ath9k_cmn_update_txpow(ah, sc->curtxpow, sc->config.txpowlimit, &sc->curtxpow); - ath9k_ps_restore(sc); - } - - if (disable_radio) { - ath_dbg(common, ATH_DBG_CONFIG, "idle: disabling radio\n"); - ath_radio_disable(sc, hw); } mutex_unlock(&sc->mutex); + ath9k_ps_restore(sc); return 0; } diff --git a/drivers/net/wireless/ath/ath9k/pci.c b/drivers/net/wireless/ath/ath9k/pci.c index 2dcdf63cb390..a439edc5dc06 100644 --- a/drivers/net/wireless/ath/ath9k/pci.c +++ b/drivers/net/wireless/ath/ath9k/pci.c @@ -307,12 +307,11 @@ static int ath_pci_suspend(struct device *device) struct ieee80211_hw *hw = pci_get_drvdata(pdev); struct ath_softc *sc = hw->priv; - ath9k_hw_set_gpio(sc->sc_ah, sc->sc_ah->led_pin, 1); - /* The device has to be moved to FULLSLEEP forcibly. * Otherwise the chip never moved to full sleep, * when no interface is up. */ + ath9k_hw_disable(sc->sc_ah); ath9k_hw_setpower(sc->sc_ah, ATH9K_PM_FULL_SLEEP); return 0; @@ -321,8 +320,6 @@ static int ath_pci_suspend(struct device *device) static int ath_pci_resume(struct device *device) { struct pci_dev *pdev = to_pci_dev(device); - struct ieee80211_hw *hw = pci_get_drvdata(pdev); - struct ath_softc *sc = hw->priv; u32 val; /* @@ -334,22 +331,6 @@ static int ath_pci_resume(struct device *device) if ((val & 0x0000ff00) != 0) pci_write_config_dword(pdev, 0x40, val & 0xffff00ff); - ath9k_ps_wakeup(sc); - /* Enable LED */ - ath9k_hw_cfg_output(sc->sc_ah, sc->sc_ah->led_pin, - AR_GPIO_OUTPUT_MUX_AS_OUTPUT); - ath9k_hw_set_gpio(sc->sc_ah, sc->sc_ah->led_pin, 0); - - /* - * Reset key cache to sane defaults (all entries cleared) instead of - * semi-random values after suspend/resume. - */ - ath9k_cmn_init_crypto(sc->sc_ah); - ath9k_ps_restore(sc); - - sc->ps_idle = true; - ath_radio_disable(sc, hw); - return 0; } |
