summaryrefslogtreecommitdiffstats
path: root/drivers/net/wireless/ath/ath5k/base.c
diff options
context:
space:
mode:
Diffstat (limited to 'drivers/net/wireless/ath/ath5k/base.c')
-rw-r--r--drivers/net/wireless/ath/ath5k/base.c18
1 files changed, 3 insertions, 15 deletions
diff --git a/drivers/net/wireless/ath/ath5k/base.c b/drivers/net/wireless/ath/ath5k/base.c
index a4c086f069b1..e63b7c40d0ee 100644
--- a/drivers/net/wireless/ath/ath5k/base.c
+++ b/drivers/net/wireless/ath/ath5k/base.c
@@ -1903,17 +1903,6 @@ accept:
rxs->noise = sc->ah->ah_noise_floor;
rxs->signal = rxs->noise + rs.rs_rssi;
- /* An rssi of 35 indicates you should be able use
- * 54 Mbps reliably. A more elaborate scheme can be used
- * here but it requires a map of SNR/throughput for each
- * possible mode used */
- rxs->qual = rs.rs_rssi * 100 / 35;
-
- /* rssi can be more than 35 though, anything above that
- * should be considered at 100% */
- if (rxs->qual > 100)
- rxs->qual = 100;
-
rxs->antenna = rs.rs_antenna;
rxs->rate_idx = ath5k_hw_to_driver_rix(sc, rs.rs_rate);
rxs->flag |= ath5k_rx_decrypted(sc, ds, skb, &rs);
@@ -2381,6 +2370,9 @@ ath5k_init(struct ath5k_softc *sc)
*/
ath5k_stop_locked(sc);
+ /* Set PHY calibration interval */
+ ah->ah_cal_intval = ath5k_calinterval;
+
/*
* The basic interface to setting the hardware in a good
* state is ``reset''. On return the hardware is known to
@@ -2408,10 +2400,6 @@ ath5k_init(struct ath5k_softc *sc)
/* Set ack to be sent at low bit-rates */
ath5k_hw_set_ack_bitrate_high(ah, false);
-
- /* Set PHY calibration inteval */
- ah->ah_cal_intval = ath5k_calinterval;
-
ret = 0;
done:
mmiowb();
OpenPOWER on IntegriCloud