diff options
Diffstat (limited to 'arch/i386/mach-voyager/voyager_basic.c')
| -rw-r--r-- | arch/i386/mach-voyager/voyager_basic.c | 325 |
1 files changed, 325 insertions, 0 deletions
diff --git a/arch/i386/mach-voyager/voyager_basic.c b/arch/i386/mach-voyager/voyager_basic.c new file mode 100644 index 000000000000..602aea240e9b --- /dev/null +++ b/arch/i386/mach-voyager/voyager_basic.c @@ -0,0 +1,325 @@ +/* Copyright (C) 1999,2001 + * + * Author: J.E.J.Bottomley@HansenPartnership.com + * + * linux/arch/i386/kernel/voyager.c + * + * This file contains all the voyager specific routines for getting + * initialisation of the architecture to function. For additional + * features see: + * + * voyager_cat.c - Voyager CAT bus interface + * voyager_smp.c - Voyager SMP hal (emulates linux smp.c) + */ + +#include <linux/config.h> +#include <linux/module.h> +#include <linux/types.h> +#include <linux/sched.h> +#include <linux/ptrace.h> +#include <linux/ioport.h> +#include <linux/interrupt.h> +#include <linux/init.h> +#include <linux/delay.h> +#include <linux/reboot.h> +#include <linux/sysrq.h> +#include <asm/io.h> +#include <asm/voyager.h> +#include <asm/vic.h> +#include <linux/pm.h> +#include <linux/irq.h> +#include <asm/tlbflush.h> +#include <asm/arch_hooks.h> + +/* + * Power off function, if any + */ +void (*pm_power_off)(void); + +int voyager_level = 0; + +struct voyager_SUS *voyager_SUS = NULL; + +#ifdef CONFIG_SMP +static void +voyager_dump(int dummy1, struct pt_regs *dummy2, struct tty_struct *dummy3) +{ + /* get here via a sysrq */ + voyager_smp_dump(); +} + +static struct sysrq_key_op sysrq_voyager_dump_op = { + .handler = voyager_dump, + .help_msg = "Voyager", + .action_msg = "Dump Voyager Status", +}; +#endif + +void +voyager_detect(struct voyager_bios_info *bios) +{ + if(bios->len != 0xff) { + int class = (bios->class_1 << 8) + | (bios->class_2 & 0xff); + + printk("Voyager System detected.\n" + " Class %x, Revision %d.%d\n", + class, bios->major, bios->minor); + if(class == VOYAGER_LEVEL4) + voyager_level = 4; + else if(class < VOYAGER_LEVEL5_AND_ABOVE) + voyager_level = 3; + else + voyager_level = 5; + printk(" Architecture Level %d\n", voyager_level); + if(voyager_level < 4) + printk("\n**WARNING**: Voyager HAL only supports Levels 4 and 5 Architectures at the moment\n\n"); + /* install the power off handler */ + pm_power_off = voyager_power_off; +#ifdef CONFIG_SMP + register_sysrq_key('v', &sysrq_voyager_dump_op); +#endif + } else { + printk("\n\n**WARNING**: No Voyager Subsystem Found\n"); + } +} + +void +voyager_system_interrupt(int cpl, void *dev_id, struct pt_regs *regs) +{ + printk("Voyager: detected system interrupt\n"); +} + +/* Routine to read information from the extended CMOS area */ +__u8 +voyager_extended_cmos_read(__u16 addr) +{ + outb(addr & 0xff, 0x74); + outb((addr >> 8) & 0xff, 0x75); + return inb(0x76); +} + +/* internal definitions for the SUS Click Map of memory */ + +#define CLICK_ENTRIES 16 +#define CLICK_SIZE 4096 /* click to byte conversion for Length */ + +typedef struct ClickMap { + struct Entry { + __u32 Address; + __u32 Length; + } Entry[CLICK_ENTRIES]; +} ClickMap_t; + + +/* This routine is pretty much an awful hack to read the bios clickmap by + * mapping it into page 0. There are usually three regions in the map: + * Base Memory + * Extended Memory + * zero length marker for end of map + * + * Returns are 0 for failure and 1 for success on extracting region. + */ +int __init +voyager_memory_detect(int region, __u32 *start, __u32 *length) +{ + int i; + int retval = 0; + __u8 cmos[4]; + ClickMap_t *map; + unsigned long map_addr; + unsigned long old; + + if(region >= CLICK_ENTRIES) { + printk("Voyager: Illegal ClickMap region %d\n", region); + return 0; + } + + for(i = 0; i < sizeof(cmos); i++) + cmos[i] = voyager_extended_cmos_read(VOYAGER_MEMORY_CLICKMAP + i); + + map_addr = *(unsigned long *)cmos; + + /* steal page 0 for this */ + old = pg0[0]; + pg0[0] = ((map_addr & PAGE_MASK) | _PAGE_RW | _PAGE_PRESENT); + local_flush_tlb(); + /* now clear everything out but page 0 */ + map = (ClickMap_t *)(map_addr & (~PAGE_MASK)); + + /* zero length is the end of the clickmap */ + if(map->Entry[region].Length != 0) { + *length = map->Entry[region].Length * CLICK_SIZE; + *start = map->Entry[region].Address; + retval = 1; + } + + /* replace the mapping */ + pg0[0] = old; + local_flush_tlb(); + return retval; +} + +/* voyager specific handling code for timer interrupts. Used to hand + * off the timer tick to the SMP code, since the VIC doesn't have an + * internal timer (The QIC does, but that's another story). */ +void +voyager_timer_interrupt(struct pt_regs *regs) +{ + if((jiffies & 0x3ff) == 0) { + + /* There seems to be something flaky in either + * hardware or software that is resetting the timer 0 + * count to something much higher than it should be + * This seems to occur in the boot sequence, just + * before root is mounted. Therefore, every 10 + * seconds or so, we sanity check the timer zero count + * and kick it back to where it should be. + * + * FIXME: This is the most awful hack yet seen. I + * should work out exactly what is interfering with + * the timer count settings early in the boot sequence + * and swiftly introduce it to something sharp and + * pointy. */ + __u16 val; + extern spinlock_t i8253_lock; + + spin_lock(&i8253_lock); + + outb_p(0x00, 0x43); + val = inb_p(0x40); + val |= inb(0x40) << 8; + spin_unlock(&i8253_lock); + + if(val > LATCH) { + printk("\nVOYAGER: countdown timer value too high (%d), resetting\n\n", val); + spin_lock(&i8253_lock); + outb(0x34,0x43); + outb_p(LATCH & 0xff , 0x40); /* LSB */ + outb(LATCH >> 8 , 0x40); /* MSB */ + spin_unlock(&i8253_lock); + } + } +#ifdef CONFIG_SMP + smp_vic_timer_interrupt(regs); +#endif +} + +void +voyager_power_off(void) +{ + printk("VOYAGER Power Off\n"); + + if(voyager_level == 5) { + voyager_cat_power_off(); + } else if(voyager_level == 4) { + /* This doesn't apparently work on most L4 machines, + * but the specs say to do this to get automatic power + * off. Unfortunately, if it doesn't power off the + * machine, it ends up doing a cold restart, which + * isn't really intended, so comment out the code */ +#if 0 + int port; + + + /* enable the voyager Configuration Space */ + outb((inb(VOYAGER_MC_SETUP) & 0xf0) | 0x8, + VOYAGER_MC_SETUP); + /* the port for the power off flag is an offset from the + floating base */ + port = (inb(VOYAGER_SSPB_RELOCATION_PORT) << 8) + 0x21; + /* set the power off flag */ + outb(inb(port) | 0x1, port); +#endif + } + /* and wait for it to happen */ + for(;;) { + __asm("cli"); + __asm("hlt"); + } +} + +/* copied from process.c */ +static inline void +kb_wait(void) +{ + int i; + + for (i=0; i<0x10000; i++) + if ((inb_p(0x64) & 0x02) == 0) + break; +} + +void +machine_restart(char *cmd) +{ + printk("Voyager Warm Restart\n"); + kb_wait(); + + if(voyager_level == 5) { + /* write magic values to the RTC to inform system that + * shutdown is beginning */ + outb(0x8f, 0x70); + outb(0x5 , 0x71); + + udelay(50); + outb(0xfe,0x64); /* pull reset low */ + } else if(voyager_level == 4) { + __u16 catbase = inb(VOYAGER_SSPB_RELOCATION_PORT)<<8; + __u8 basebd = inb(VOYAGER_MC_SETUP); + + outb(basebd | 0x08, VOYAGER_MC_SETUP); + outb(0x02, catbase + 0x21); + } + for(;;) { + asm("cli"); + asm("hlt"); + } +} + +EXPORT_SYMBOL(machine_restart); + +void +mca_nmi_hook(void) +{ + __u8 dumpval __attribute__((unused)) = inb(0xf823); + __u8 swnmi __attribute__((unused)) = inb(0xf813); + + /* FIXME: assume dump switch pressed */ + /* check to see if the dump switch was pressed */ + VDEBUG(("VOYAGER: dumpval = 0x%x, swnmi = 0x%x\n", dumpval, swnmi)); + /* clear swnmi */ + outb(0xff, 0xf813); + /* tell SUS to ignore dump */ + if(voyager_level == 5 && voyager_SUS != NULL) { + if(voyager_SUS->SUS_mbox == VOYAGER_DUMP_BUTTON_NMI) { + voyager_SUS->kernel_mbox = VOYAGER_NO_COMMAND; + voyager_SUS->kernel_flags |= VOYAGER_OS_IN_PROGRESS; + udelay(1000); + voyager_SUS->kernel_mbox = VOYAGER_IGNORE_DUMP; + voyager_SUS->kernel_flags &= ~VOYAGER_OS_IN_PROGRESS; + } + } + printk(KERN_ERR "VOYAGER: Dump switch pressed, printing CPU%d tracebacks\n", smp_processor_id()); + show_stack(NULL, NULL); + show_state(); +} + + + +void +machine_halt(void) +{ + /* treat a halt like a power off */ + machine_power_off(); +} + +EXPORT_SYMBOL(machine_halt); + +void machine_power_off(void) +{ + if (pm_power_off) + pm_power_off(); +} + +EXPORT_SYMBOL(machine_power_off); |
