summaryrefslogtreecommitdiffstats
path: root/Documentation/DocBook/libata.tmpl
diff options
context:
space:
mode:
Diffstat (limited to 'Documentation/DocBook/libata.tmpl')
-rw-r--r--Documentation/DocBook/libata.tmpl10
1 files changed, 5 insertions, 5 deletions
diff --git a/Documentation/DocBook/libata.tmpl b/Documentation/DocBook/libata.tmpl
index 8c5411cfeaf0..cdd1bb9aac0d 100644
--- a/Documentation/DocBook/libata.tmpl
+++ b/Documentation/DocBook/libata.tmpl
@@ -1032,7 +1032,7 @@ and other resources, etc.
<listitem>
<para>
This is indicated by ICRC bit in the ERROR register and
- means that corruption occurred during data transfer. Upto
+ means that corruption occurred during data transfer. Up to
ATA/ATAPI-7, the standard specifies that this bit is only
applicable to UDMA transfers but ATA/ATAPI-8 draft revision
1f says that the bit may be applicable to multiword DMA and
@@ -1045,10 +1045,10 @@ and other resources, etc.
<term>ABRT error during data transfer or on completion</term>
<listitem>
<para>
- Upto ATA/ATAPI-7, the standard specifies that ABRT could be
+ Up to ATA/ATAPI-7, the standard specifies that ABRT could be
set on ICRC errors and on cases where a device is not able
to complete a command. Combined with the fact that MWDMA
- and PIO transfer errors aren't allowed to use ICRC bit upto
+ and PIO transfer errors aren't allowed to use ICRC bit up to
ATA/ATAPI-7, it seems to imply that ABRT bit alone could
indicate tranfer errors.
</para>
@@ -1122,7 +1122,7 @@ and other resources, etc.
<para>
Depending on commands, not all STATUS/ERROR bits are
applicable. These non-applicable bits are marked with
- &quot;na&quot; in the output descriptions but upto ATA/ATAPI-7
+ &quot;na&quot; in the output descriptions but up to ATA/ATAPI-7
no definition of &quot;na&quot; can be found. However,
ATA/ATAPI-8 draft revision 1f describes &quot;N/A&quot; as
follows.
@@ -1507,7 +1507,7 @@ and other resources, etc.
<listitem>
<para>
- CHS set up with INITIALIZE DEVICE PARAMETERS (seldomly used)
+ CHS set up with INITIALIZE DEVICE PARAMETERS (seldom used)
</para>
</listitem>
OpenPOWER on IntegriCloud