usb: musb: dsps: remove babble check from dsps irq handler

musb->int_usb already contains the correct
information for musb-core to handle babble.

In fact, this very check was just causing a
nonsensical babble interrupt storm.

With this I can get test.sh to run and, even though
all tests fail with timeout, that's still better
than locking up the system due to IRQ storm.

Also, if I remove g_zero and load g_mass_storage,
then everything works fine again.

Tested-by: Bin Liu <b-liu@ti.com>
Signed-off-by: Felipe Balbi <balbi@ti.com>

2 files changed, 1 insertions, 23 deletions

diff --git a/drivers/usb/musb/musb_core.c b/drivers/usb/musb/musb_core.c
index 7ac69799a1db..d7730c7e7938 100644
--- a/drivers/usb/musb/musb_core.c
+++ b/drivers/usb/musb/musb_core.c
@@ -879,7 +879,7 @@ b_host:
 			 * the session.
 			 */
 			if (power & MUSB_POWER_HSMODE) {
-				ERR("Stopping host session -- babble\n");
+				dev_err(musb->controller, "Babble\n");
 				musb_writeb(musb->mregs, MUSB_DEVCTL, 0);
 
 				if (is_host_active(musb)) {
diff --git a/drivers/usb/musb/musb_dsps.c b/drivers/usb/musb/musb_dsps.c
index af614f49cd98..8f96e79dd069 100644
--- a/drivers/usb/musb/musb_dsps.c
+++ b/drivers/usb/musb/musb_dsps.c
@@ -330,28 +330,6 @@ static irqreturn_t dsps_interrupt(int irq, void *hci)
 
 	dev_dbg(musb->controller, "usbintr (%x) epintr(%x)\n",
 			usbintr, epintr);
-	/*
-	 * DRVVBUS IRQs are the only proxy we have (a very poor one!) for
-	 * DSPS IP's missing ID change IRQ.  We need an ID change IRQ to
-	 * switch appropriately between halves of the OTG state machine.
-	 * Managing DEVCTL.SESSION per Mentor docs requires that we know its
-	 * value but DEVCTL.BDEVICE is invalid without DEVCTL.SESSION set.
-	 * Also, DRVVBUS pulses for SRP (but not at 5V) ...
-	 */
-	if (is_host_active(musb) && usbintr & MUSB_INTR_BABBLE) {
-		pr_info("CAUTION: musb: Babble Interrupt Occurred\n");
-
-		/*
-		 * When a babble condition occurs, the musb controller removes
-		 * the session and is no longer in host mode. Hence, all
-		 * devices connected to its root hub get disconnected.
-		 *
-		 * Hand this error down to the musb core isr, so it can
-		 * recover.
-		 */
-		musb->int_usb = MUSB_INTR_BABBLE | MUSB_INTR_DISCONNECT;
-		musb->int_tx = musb->int_rx = 0;
-	}
 
 	if (usbintr & ((1 << wrp->drvvbus) << wrp->usb_shift)) {
 		int drvvbus = dsps_readl(reg_base, wrp->status);