|
|
The pipeliner is asserting because the serialization step that
occurs at the end is deleting an instruction. The assert
occurs later on because there is a use without a definition.
The problem occurs when an instruction defines a value used
by a REQ_SEQUENCE and that value is used by a COPY instruction.
The latencies between these instructions are zero, so they are
put in to the same packet. The serialization code is unable to
handle this correctly, and ends up putting the REG_SEQUENCE
before its definition.
There is special code in the serialization step that attempts
to handle zero-cost instructions (phis, copy, reg_sequence)
differently than regular instructions. Unfortunately, this means
the order does not come out correct.
This patch simplifies the code by changing the seperate steps for
handling zero-cost and regular instructions. Only phis are
handled separate now, since they should occurs first. Then, this
patch adds checks to make use the MoveUse is set to the smallest
value if there are multiple uses in a cycle.
Patch by Brendon Cahoon.
llvm-svn: 328540
|
