From 4cf3326ab5f34a333a46c59d0d3783db9cef13bf Mon Sep 17 00:00:00 2001 From: Ludovic Desroches Date: Mon, 21 May 2012 12:23:27 +0200 Subject: ARM: at91: add atmel-mci support for chips and boards which can use it Since atmel-mci driver supports all atmel mci versions, use it instead of the deprecated at91_mci driver. Platform data and all related configuration are removed. Signed-off-by: Ludovic Desroches [nicolas.ferre@atmel.com: remove at91_mci platform data] Signed-off-by: Nicolas Ferre --- arch/arm/mach-at91/board-rm9200ek.c | 14 +++++++------- 1 file changed, 7 insertions(+), 7 deletions(-) (limited to 'arch/arm/mach-at91/board-rm9200ek.c') diff --git a/arch/arm/mach-at91/board-rm9200ek.c b/arch/arm/mach-at91/board-rm9200ek.c index 2b15b8adec4c..58144a0a5388 100644 --- a/arch/arm/mach-at91/board-rm9200ek.c +++ b/arch/arm/mach-at91/board-rm9200ek.c @@ -69,12 +69,12 @@ static struct at91_udc_data __initdata ek_udc_data = { }; #ifndef CONFIG_MTD_AT91_DATAFLASH_CARD -static struct at91_mmc_data __initdata ek_mmc_data = { - .det_pin = AT91_PIN_PB27, - .slot_b = 0, - .wire4 = 1, - .wp_pin = AT91_PIN_PA17, - .vcc_pin = -EINVAL, +static struct mci_platform_data __initdata ek_mci0_data = { + .slot[0] = { + .bus_width = 4, + .detect_pin = AT91_PIN_PB27, + .wp_pin = AT91_PIN_PA17, + } }; #endif @@ -176,7 +176,7 @@ static void __init ek_board_init(void) #else /* MMC */ at91_set_gpio_output(AT91_PIN_PB22, 1); /* this MMC card slot can optionally use SPI signaling (CS3). */ - at91_add_device_mmc(0, &ek_mmc_data); + at91_add_device_mci(0, &ek_mci0_data); #endif /* NOR Flash */ platform_device_register(&ek_flash); -- cgit v1.2.1