summaryrefslogtreecommitdiffstats
path: root/drivers/net/jme.c
diff options
context:
space:
mode:
Diffstat (limited to 'drivers/net/jme.c')
-rw-r--r--drivers/net/jme.c70
1 files changed, 29 insertions, 41 deletions
diff --git a/drivers/net/jme.c b/drivers/net/jme.c
index 665e70d620fc..15035cb1738a 100644
--- a/drivers/net/jme.c
+++ b/drivers/net/jme.c
@@ -435,15 +435,18 @@ jme_check_link(struct net_device *netdev, int testonly)
GHC_DPX);
switch (phylink & PHY_LINK_SPEED_MASK) {
case PHY_LINK_SPEED_10M:
- ghc |= GHC_SPEED_10M;
+ ghc |= GHC_SPEED_10M |
+ GHC_TO_CLK_PCIE | GHC_TXMAC_CLK_PCIE;
strcat(linkmsg, "10 Mbps, ");
break;
case PHY_LINK_SPEED_100M:
- ghc |= GHC_SPEED_100M;
+ ghc |= GHC_SPEED_100M |
+ GHC_TO_CLK_PCIE | GHC_TXMAC_CLK_PCIE;
strcat(linkmsg, "100 Mbps, ");
break;
case PHY_LINK_SPEED_1000M:
- ghc |= GHC_SPEED_1000M;
+ ghc |= GHC_SPEED_1000M |
+ GHC_TO_CLK_GPHY | GHC_TXMAC_CLK_GPHY;
strcat(linkmsg, "1000 Mbps, ");
break;
default:
@@ -463,14 +466,6 @@ jme_check_link(struct net_device *netdev, int testonly)
TXTRHD_TXREN |
((8 << TXTRHD_TXRL_SHIFT) & TXTRHD_TXRL));
}
- strcat(linkmsg, (phylink & PHY_LINK_DUPLEX) ?
- "Full-Duplex, " :
- "Half-Duplex, ");
-
- if (phylink & PHY_LINK_MDI_STAT)
- strcat(linkmsg, "MDI-X");
- else
- strcat(linkmsg, "MDI");
gpreg1 = GPREG1_DEFAULT;
if (is_buggy250(jme->pdev->device, jme->chiprev)) {
@@ -492,11 +487,17 @@ jme_check_link(struct net_device *netdev, int testonly)
break;
}
}
- jwrite32(jme, JME_GPREG1, gpreg1);
- jme->reg_ghc = ghc;
+ jwrite32(jme, JME_GPREG1, gpreg1);
jwrite32(jme, JME_GHC, ghc);
+ jme->reg_ghc = ghc;
+ strcat(linkmsg, (phylink & PHY_LINK_DUPLEX) ?
+ "Full-Duplex, " :
+ "Half-Duplex, ");
+ strcat(linkmsg, (phylink & PHY_LINK_MDI_STAT) ?
+ "MDI-X" :
+ "MDI");
msg_link(jme, "Link is up at %s.\n", linkmsg);
netif_carrier_on(netdev);
} else {
@@ -931,7 +932,6 @@ jme_alloc_and_feed_skb(struct jme_adapter *jme, int idx)
cpu_to_le16(RXWBFLAG_DEST_MUL))
++(NET_STAT(jme).multicast);
- jme->dev->last_rx = jiffies;
NET_STAT(jme).rx_bytes += framesize;
++(NET_STAT(jme).rx_packets);
}
@@ -2591,14 +2591,6 @@ static const struct ethtool_ops jme_ethtool_ops = {
static int
jme_pci_dma64(struct pci_dev *pdev)
{
- if (!pci_set_dma_mask(pdev, DMA_64BIT_MASK))
- if (!pci_set_consistent_dma_mask(pdev, DMA_64BIT_MASK))
- return 1;
-
- if (!pci_set_dma_mask(pdev, DMA_40BIT_MASK))
- if (!pci_set_consistent_dma_mask(pdev, DMA_40BIT_MASK))
- return 1;
-
if (!pci_set_dma_mask(pdev, DMA_32BIT_MASK))
if (!pci_set_consistent_dma_mask(pdev, DMA_32BIT_MASK))
return 0;
@@ -2626,6 +2618,18 @@ jme_check_hw_ver(struct jme_adapter *jme)
jme->chiprev = (chipmode & CM_CHIPREV_MASK) >> CM_CHIPREV_SHIFT;
}
+static const struct net_device_ops jme_netdev_ops = {
+ .ndo_open = jme_open,
+ .ndo_stop = jme_close,
+ .ndo_validate_addr = eth_validate_addr,
+ .ndo_start_xmit = jme_start_xmit,
+ .ndo_set_mac_address = jme_set_macaddr,
+ .ndo_set_multicast_list = jme_set_multi,
+ .ndo_change_mtu = jme_change_mtu,
+ .ndo_tx_timeout = jme_tx_timeout,
+ .ndo_vlan_rx_register = jme_vlan_rx_register,
+};
+
static int __devinit
jme_init_one(struct pci_dev *pdev,
const struct pci_device_id *ent)
@@ -2675,17 +2679,9 @@ jme_init_one(struct pci_dev *pdev,
rc = -ENOMEM;
goto err_out_release_regions;
}
- netdev->open = jme_open;
- netdev->stop = jme_close;
- netdev->hard_start_xmit = jme_start_xmit;
- netdev->set_mac_address = jme_set_macaddr;
- netdev->set_multicast_list = jme_set_multi;
- netdev->change_mtu = jme_change_mtu;
+ netdev->netdev_ops = &jme_netdev_ops;
netdev->ethtool_ops = &jme_ethtool_ops;
- netdev->tx_timeout = jme_tx_timeout;
netdev->watchdog_timeo = TX_TIMEOUT;
- netdev->vlan_rx_register = jme_vlan_rx_register;
- NETDEV_GET_STATS(netdev, &jme_get_stats);
netdev->features = NETIF_F_HW_CSUM |
NETIF_F_SG |
NETIF_F_TSO |
@@ -2861,18 +2857,10 @@ jme_init_one(struct pci_dev *pdev,
goto err_out_free_shadow;
}
- msg_probe(jme,
- "JMC250 gigabit%s ver:%x rev:%x "
- "macaddr:%02x:%02x:%02x:%02x:%02x:%02x\n",
+ msg_probe(jme, "JMC250 gigabit%s ver:%x rev:%x macaddr:%pM\n",
(jme->fpgaver != 0) ? " (FPGA)" : "",
(jme->fpgaver != 0) ? jme->fpgaver : jme->chiprev,
- jme->rev,
- netdev->dev_addr[0],
- netdev->dev_addr[1],
- netdev->dev_addr[2],
- netdev->dev_addr[3],
- netdev->dev_addr[4],
- netdev->dev_addr[5]);
+ jme->rev, netdev->dev_addr);
return 0;
OpenPOWER on IntegriCloud