diff options
Diffstat (limited to 'drivers/mmc/host/dw_mmc.h')
| -rw-r--r-- | drivers/mmc/host/dw_mmc.h | 27 |
1 files changed, 15 insertions, 12 deletions
diff --git a/drivers/mmc/host/dw_mmc.h b/drivers/mmc/host/dw_mmc.h index 1424bd490dd1..46e9f8ec5398 100644 --- a/drivers/mmc/host/dw_mmc.h +++ b/drivers/mmc/host/dw_mmc.h @@ -65,8 +65,7 @@ struct dw_mci_dma_slave { * @fifo_reg: Pointer to MMIO registers for data FIFO * @sg: Scatterlist entry currently being processed by PIO code, if any. * @sg_miter: PIO mapping scatterlist iterator. - * @cur_slot: The slot which is currently using the controller. - * @mrq: The request currently being processed on @cur_slot, + * @mrq: The request currently being processed on @slot, * or NULL if the controller is idle. * @cmd: The command currently being sent to the card, or NULL. * @data: The data currently being transferred, or NULL if no data @@ -102,7 +101,6 @@ struct dw_mci_dma_slave { * @bus_hz: The rate of @mck in Hz. This forms the basis for MMC bus * rate and timeout calculations. * @current_speed: Configured rate of the controller. - * @num_slots: Number of slots available. * @fifoth_val: The value of FIFOTH register. * @verid: Denote Version ID. * @dev: Device associated with the MMC controller. @@ -134,17 +132,17 @@ struct dw_mci_dma_slave { * ======= * * @lock is a softirq-safe spinlock protecting @queue as well as + * @slot, @mrq and @state. These must always be updated * at the same time while holding @lock. + * The @mrq field of struct dw_mci_slot is also protected by @lock, + * and must always be written at the same time as the slot is added to + * @queue. * * @irq_lock is an irq-safe spinlock protecting the INTMASK register * to allow the interrupt handler to modify it directly. Held for only long * enough to read-modify-write INTMASK and no other locks are grabbed when * holding this one. * - * The @mrq field of struct dw_mci_slot is also protected by @lock, - * and must always be written at the same time as the slot is added to - * @queue. - * * @pending_events and @completed_events are accessed using atomic bit * operations, so they don't need any locking. * @@ -253,8 +251,6 @@ struct dma_pdata; /* Board platform data */ struct dw_mci_board { - u32 num_slots; - unsigned int bus_hz; /* Clock speed at the cclk_in pad */ u32 caps; /* Capabilities */ @@ -318,11 +314,12 @@ struct dw_mci_board { #define SDMMC_BUFADDR 0x098 #define SDMMC_CDTHRCTL 0x100 #define SDMMC_UHS_REG_EXT 0x108 +#define SDMMC_DDR_REG 0x10c #define SDMMC_ENABLE_SHIFT 0x110 #define SDMMC_DATA(x) (x) /* -* Registers to support idmac 64-bit address mode -*/ + * Registers to support idmac 64-bit address mode + */ #define SDMMC_DBADDRL 0x088 #define SDMMC_DBADDRU 0x08c #define SDMMC_IDSTS64 0x090 @@ -443,13 +440,19 @@ struct dw_mci_board { #define SDMMC_CARD_WR_THR_EN BIT(2) #define SDMMC_CARD_RD_THR_EN BIT(0) /* UHS-1 register defines */ +#define SDMMC_UHS_DDR BIT(16) #define SDMMC_UHS_18V BIT(0) +/* DDR register defines */ +#define SDMMC_DDR_HS400 BIT(31) +/* Enable shift register defines */ +#define SDMMC_ENABLE_PHASE BIT(0) /* All ctrl reset bits */ #define SDMMC_CTRL_ALL_RESET_FLAGS \ (SDMMC_CTRL_RESET | SDMMC_CTRL_FIFO_RESET | SDMMC_CTRL_DMA_RESET) /* FIFO register access macros. These should not change the data endian-ness - * as they are written to memory to be dealt with by the upper layers */ + * as they are written to memory to be dealt with by the upper layers + */ #define mci_fifo_readw(__reg) __raw_readw(__reg) #define mci_fifo_readl(__reg) __raw_readl(__reg) #define mci_fifo_readq(__reg) __raw_readq(__reg) |
