diff options
Diffstat (limited to 'drivers/i2c/chips/Kconfig')
| -rw-r--r-- | drivers/i2c/chips/Kconfig | 48 |
1 files changed, 0 insertions, 48 deletions
diff --git a/drivers/i2c/chips/Kconfig b/drivers/i2c/chips/Kconfig index 59c3d23f5bdc..c80312c1f382 100644 --- a/drivers/i2c/chips/Kconfig +++ b/drivers/i2c/chips/Kconfig @@ -16,43 +16,6 @@ config DS1682 This driver can also be built as a module. If so, the module will be called ds1682. -config AT24 - tristate "EEPROMs from most vendors" - depends on SYSFS && EXPERIMENTAL - help - Enable this driver to get read/write support to most I2C EEPROMs, - after you configure the driver to know about each EEPROM on - your target board. Use these generic chip names, instead of - vendor-specific ones like at24c64 or 24lc02: - - 24c00, 24c01, 24c02, spd (readonly 24c02), 24c04, 24c08, - 24c16, 24c32, 24c64, 24c128, 24c256, 24c512, 24c1024 - - Unless you like data loss puzzles, always be sure that any chip - you configure as a 24c32 (32 kbit) or larger is NOT really a - 24c16 (16 kbit) or smaller, and vice versa. Marking the chip - as read-only won't help recover from this. Also, if your chip - has any software write-protect mechanism you may want to review the - code to make sure this driver won't turn it on by accident. - - If you use this with an SMBus adapter instead of an I2C adapter, - full functionality is not available. Only smaller devices are - supported (24c16 and below, max 4 kByte). - - This driver can also be built as a module. If so, the module - will be called at24. - -config SENSORS_EEPROM - tristate "EEPROM reader" - depends on EXPERIMENTAL - help - If you say yes here you get read-only access to the EEPROM data - available on modern memory DIMMs and Sony Vaio laptops. Such - EEPROMs could theoretically be available on other devices as well. - - This driver can also be built as a module. If so, the module - will be called eeprom. - config SENSORS_PCF8574 tristate "Philips PCF8574 and PCF8574A (DEPRECATED)" depends on EXPERIMENTAL && GPIO_PCF857X = "n" @@ -139,15 +102,4 @@ config SENSORS_TSL2550 This driver can also be built as a module. If so, the module will be called tsl2550. -config MCU_MPC8349EMITX - tristate "MPC8349E-mITX MCU driver" - depends on I2C && PPC_83xx - select GENERIC_GPIO - select ARCH_REQUIRE_GPIOLIB - help - Say Y here to enable soft power-off functionality on the Freescale - boards with the MPC8349E-mITX-compatible MCU chips. This driver will - also register MCU GPIOs with the generic GPIO API, so you'll able - to use MCU pins as GPIOs. - endmenu |
