i2c: xlr: add support for Sigma Designs controller variant

Sigma Designs chips use a variant of this controller with the following
differences:

- The BUSY bit in the STATUS register is inverted
- Bit 8 of the CONFIG register must be set
- The controller can generate interrupts

This patch adds support for the first two of these.  It also calculates
and sets the correct clock divisor if a clk is provided.  The bus
frequency is optionally speficied in the device tree node.

Signed-off-by: Mans Rullgard <mans@mansr.com>
Signed-off-by: Wolfram Sang <wsa@the-dreams.de>

1 files changed, 3 insertions, 3 deletions

diff --git a/drivers/i2c/busses/Kconfig b/drivers/i2c/busses/Kconfig
index 69c46fe13777..eaa7b4a0e484 100644
--- a/drivers/i2c/busses/Kconfig
+++ b/drivers/i2c/busses/Kconfig
@@ -963,11 +963,11 @@ config I2C_XILINX
 	  will be called xilinx_i2c.
 
 config I2C_XLR
-	tristate "XLR I2C support"
-	depends on CPU_XLR
+	tristate "Netlogic XLR and Sigma Designs I2C support"
+	depends on CPU_XLR || ARCH_TANGOX
 	help
 	  This driver enables support for the on-chip I2C interface of
-	  the Netlogic XLR/XLS MIPS processors.
+	  the Netlogic XLR/XLS MIPS processors and Sigma Designs SOCs.
 
 	  This driver can also be built as a module.  If so, the module
 	  will be called i2c-xlr.