AMCC Ocotea Board Last Update: March 2, 2004 ======================================================================= This file contains some handy info regarding U-Boot and the AMCC Ocotea 440gx evalutation board. See the README.ppc440 for additional information. SWITCH SETTINGS & JUMPERS ========================== Here's what I've been using successfully. If you feel inclined to change things ... please read the docs! DIPSW U46 U80 ------------------------ SW 1 off off SW 2 on off SW 3 off off SW 4 off off SW 5 off off SW 6 on on SW 7 on off SW 8 on off J41: strapped J42: open All others are factory default. I2C Information ===================== See README.ebony for information. PCI =========================== Untested at the time of writing. PPC440GX Ethernet EMACs =========================== All EMAC ports have been tested and are known to work with EPS Group 4. Special note about the Cicada CIS8201: The CIS8201 Gigabit PHY comes up in GMII mode by default. One must hit an extended register to allow use of RGMII mode. This has been done in the 440gx_enet.c file with a #ifdef/endif pair. AMCC does not store the EMAC ethernet addresses within their PIBS bootloader. The addresses contained in the config header file are from my particular board and you _*should*_ change them to reflect your board either in the config file and/or in your environment variables. I found the addresses on labels on the bottom side of the board. BDI2k or JTAG Debugging =========================== For ease of debugging you can swap the small boot flash and external SRAM by changing U46:3 to on. You can then use the sram as your boot flash by loading the sram via the jtag debugger. Regards, --Travis