/* * Copyright (C) 2016 Stefan Roese * * SPDX-License-Identifier: GPL-2.0+ */ #include #include #include #include #include #include #include #include #include "theadorable.h" /* * FPGA programming support */ static int fpga_pre_fn(int cookie) { int gpio_config = COOKIE2CONFIG(cookie); int gpio_done = COOKIE2DONE(cookie); int ret; debug("%s (%d): cookie=%08x gpio_config=%d gpio_done=%d\n", __func__, __LINE__, cookie, gpio_config, gpio_done); /* Configure config pin */ /* Set to output */ ret = gpio_request(gpio_config, "CONFIG"); if (ret < 0) return ret; gpio_direction_output(gpio_config, 1); /* Configure done pin */ /* Set to input */ ret = gpio_request(gpio_done, "DONE"); if (ret < 0) return ret; gpio_direction_input(gpio_done); return 0; } static int fpga_config_fn(int assert, int flush, int cookie) { int gpio_config = COOKIE2CONFIG(cookie); debug("%s (%d): cookie=%08x gpio_config=%d\n", __func__, __LINE__, cookie, gpio_config); if (assert) gpio_set_value(gpio_config, 1); else gpio_set_value(gpio_config, 0); return 0; } static int fpga_write_fn(const void *buf, size_t len, int flush, int cookie) { int spi_bus = COOKIE2SPI_BUS(cookie); int spi_dev = COOKIE2SPI_DEV(cookie); struct kwspi_registers *reg; u32 control_reg; u32 config_reg; void *dst; /* * Write data to FPGA attached to SPI bus via SPI direct write. * This results in the fastest and easiest way to program the * bitstream into the FPGA. */ debug("%s (%d): cookie=%08x spi_bus=%d spi_dev=%d\n", __func__, __LINE__, cookie, spi_bus, spi_dev); if (spi_bus == 0) { reg = (struct kwspi_registers *)MVEBU_REGISTER(0x10600); dst = (void *)SPI_BUS0_DEV1_BASE; } else { reg = (struct kwspi_registers *)MVEBU_REGISTER(0x10680); dst = (void *)SPI_BUS1_DEV2_BASE; } /* Configure SPI controller for direct access mode */ control_reg = readl(®->ctrl); config_reg = readl(®->cfg); writel(0x00000214, ®->cfg); /* 27MHz clock */ writel(0x00000000, ®->dw_cfg); /* don't de-asset CS */ writel(KWSPI_CSN_ACT, ®->ctrl); /* activate CS */ /* Copy data to the SPI direct mapped window */ memcpy(dst, buf, len); /* Restore original register values */ writel(control_reg, ®->ctrl); writel(config_reg, ®->cfg); return 0; } /* Returns the state of CONF_DONE Pin */ static int fpga_done_fn(int cookie) { int gpio_done = COOKIE2DONE(cookie); unsigned long ts; debug("%s (%d): cookie=%08x gpio_done=%d\n", __func__, __LINE__, cookie, gpio_done); ts = get_timer(0); do { if (gpio_get_value(gpio_done)) return 0; } while (get_timer(ts) < 1000); /* timeout so return error */ return -ENODEV; } static altera_board_specific_func stratixv_fns = { .pre = fpga_pre_fn, .config = fpga_config_fn, .write = fpga_write_fn, .done = fpga_done_fn, }; static Altera_desc altera_fpga[] = { { /* Family */ Altera_StratixV, /* Interface type */ passive_serial, /* No limitation as additional data will be ignored */ -1, /* Device function table */ (void *)&stratixv_fns, /* Base interface address specified in driver */ NULL, /* Cookie implementation */ /* * In this 32bit word the following information is coded: * Bit 31 ... Bit 0 * SPI-Bus | SPI-Dev | Config-Pin | Done-Pin */ FPGA_COOKIE(0, 1, 26, 7) }, { /* Family */ Altera_StratixV, /* Interface type */ passive_serial, /* No limitation as additional data will be ignored */ -1, /* Device function table */ (void *)&stratixv_fns, /* Base interface address specified in driver */ NULL, /* Cookie implementation */ /* * In this 32bit word the following information is coded: * Bit 31 ... Bit 0 * SPI-Bus | SPI-Dev | Config-Pin | Done-Pin */ FPGA_COOKIE(1, 2, 29, 9) }, }; /* Add device descriptor to FPGA device table */ void board_fpga_add(void) { int i; fpga_init(); for (i = 0; i < ARRAY_SIZE(altera_fpga); i++) fpga_add(fpga_altera, &altera_fpga[i]); }