if ARCH_UNIPHIER config SYS_CONFIG_NAME default "uniphier" config ARCH_UNIPHIER_PH1_SLD3 bool "UniPhier PH1-sLD3 SoC" help This enables support for UniPhier PH1-sLD3 SoC. config ARCH_UNIPHIER_PH1_LD4 bool "UniPhier PH1-LD4 SoC" depends on !ARCH_UNIPHIER_PH1_SLD3 help This enables support for UniPhier PH1-LD4 SoC. config ARCH_UNIPHIER_PH1_PRO4 bool "UniPhier PH1-Pro4 SoC" depends on !ARCH_UNIPHIER_PH1_SLD3 && \ !ARCH_UNIPHIER_PH1_LD4 && \ !ARCH_UNIPHIER_PH1_SLD8 help This enables support for UniPhier PH1-Pro4 SoC. config ARCH_UNIPHIER_PH1_SLD8 bool "UniPhier PH1-sLD8 SoC" depends on !ARCH_UNIPHIER_PH1_SLD3 help This enables support for UniPhier PH1-sLD8 SoC. config ARCH_UNIPHIER_PH1_PRO5 bool "UniPhier PH1-Pro5 SoC" depends on !ARCH_UNIPHIER_PH1_SLD3 && \ !ARCH_UNIPHIER_PH1_LD4 && \ !ARCH_UNIPHIER_PH1_SLD8 help This enables support for UniPhier PH1-Pro5 SoC. config ARCH_UNIPHIER_PROXSTREAM2 bool "UniPhier ProXstream2 SoC" depends on !ARCH_UNIPHIER_PH1_SLD3 && \ !ARCH_UNIPHIER_PH1_LD4 && \ !ARCH_UNIPHIER_PH1_SLD8 help This enables support for UniPhier ProXstream2 SoC. config ARCH_UNIPHIER_PH1_LD6B bool "UniPhier PH1-LD6b SoC" depends on !ARCH_UNIPHIER_PH1_SLD3 && \ !ARCH_UNIPHIER_PH1_LD4 && \ !ARCH_UNIPHIER_PH1_SLD8 help This enables support for UniPhier PH1-LD6b SoC. config MICRO_SUPPORT_CARD bool "Use Micro Support Card" help This option provides support for the expansion board, available on some UniPhier reference boards. Say Y to use the on-board UART, Ether, LED devices. config CMD_PINMON bool "Enable boot mode pins monitor command" default y help The command "pinmon" shows the state of the boot mode pins. The boot mode pins are latched when the system reset is deasserted and determine which device the system should load a boot image from. config CMD_DDRPHY_DUMP bool "Enable dump command of DDR PHY parameters" depends on ARCH_UNIPHIER_PH1_LD4 || ARCH_UNIPHIER_PH1_PRO4 || \ ARCH_UNIPHIER_PH1_SLD8 help The command "ddrphy" shows the resulting parameters of DDR PHY training; it is useful for the evaluation of DDR PHY training. config CMD_DDRMPHY_DUMP bool "Enable dump command of DDR Multi PHY parameters" depends on ARCH_UNIPHIER_PROXSTREAM2 || ARCH_UNIPHIER_PH1_LD6B help The command "ddrmphy" shows the resulting parameters of DDR Multi PHY training; it is useful for the evaluation of DDR Multi PHY training. endif