/* * (C) Copyright 2010 Samsung Electronics * Naveen Krishna Ch * * SPDX-License-Identifier: GPL-2.0+ * * Note: This file contains the register description for SROMC */ #ifndef __ASM_ARCH_SROMC_H_ #define __ASM_ARCH_SROMC_H_ #define SROMC_DATA16_WIDTH(x) (1<<((x*4)+0)) #define SROMC_BYTE_ADDR_MODE(x) (1<<((x*4)+1)) /* 0-> Half-word base address*/ /* 1-> Byte base address*/ #define SROMC_WAIT_ENABLE(x) (1<<((x*4)+2)) #define SROMC_BYTE_ENABLE(x) (1<<((x*4)+3)) #define SROMC_BC_TACS(x) (x << 28) /* address set-up */ #define SROMC_BC_TCOS(x) (x << 24) /* chip selection set-up */ #define SROMC_BC_TACC(x) (x << 16) /* access cycle */ #define SROMC_BC_TCOH(x) (x << 12) /* chip selection hold */ #define SROMC_BC_TAH(x) (x << 8) /* address holding time */ #define SROMC_BC_TACP(x) (x << 4) /* page mode access cycle */ #define SROMC_BC_PMC(x) (x << 0) /* normal(1data)page mode configuration */ #ifndef __ASSEMBLY__ struct s5p_sromc { unsigned int bw; unsigned int bc[4]; }; #endif /* __ASSEMBLY__ */ /* Configure the Band Width and Bank Control Regs for required SROMC Bank */ void s5p_config_sromc(u32 srom_bank, u32 srom_bw_conf, u32 srom_bc_conf); enum { FDT_SROM_PMC, FDT_SROM_TACP, FDT_SROM_TAH, FDT_SROM_TCOH, FDT_SROM_TACC, FDT_SROM_TCOS, FDT_SROM_TACS, FDT_SROM_TIMING_COUNT, }; struct fdt_sromc { u8 bank; /* srom bank number */ u8 width; /* bus width in bytes */ unsigned int timing[FDT_SROM_TIMING_COUNT]; /* timing parameters */ }; #endif /* __ASM_ARCH_SROMC_H_ */