/* * SAMSUNG/GOOGLE Peach-Pit board device tree source * * Copyright (c) 2013 Samsung Electronics Co., Ltd. * http://www.samsung.com * * SPDX-License-Identifier: GPL-2.0+ */ /dts-v1/; #include "exynos54xx.dtsi" / { model = "Samsung/Google Peach Pi board based on Exynos5800"; cpu-model = "Exynos5800"; compatible = "google,pit-rev#", "google,pit", "google,peach", "samsung,exynos5800", "samsung,exynos5"; config { google,bad-wake-gpios = <&gpx0 6 GPIO_ACTIVE_HIGH>; hwid = "PIT TEST A-A 7848"; lazy-init = <1>; }; aliases { serial0 = "/serial@12C30000"; console = "/serial@12C30000"; pmic = "/i2c@12CA0000"; i2c104 = &i2c_tunnel; }; backlight: backlight { compatible = "pwm-backlight"; pwms = <&pwm 0 1000000 0>; brightness-levels = <0 100 500 1000 1500 2000 2500 2800>; default-brightness-level = <7>; enable-gpios = <&gpx2 2 GPIO_ACTIVE_HIGH>; power-supply = <&tps65090_fet1>; }; panel: panel { compatible = "auo,b133htn01"; power-supply = <&tps65090_fet6>; backlight = <&backlight>; port { panel_in: endpoint { remote-endpoint = <&dp_out>; }; }; }; dmc { mem-manuf = "samsung"; mem-type = "ddr3"; clock-frequency = <800000000>; arm-frequency = <900000000>; }; tmu@10060000 { samsung,min-temp = <25>; samsung,max-temp = <125>; samsung,start-warning = <95>; samsung,start-tripping = <105>; samsung,hw-tripping = <110>; samsung,efuse-min-value = <40>; samsung,efuse-value = <55>; samsung,efuse-max-value = <100>; samsung,slope = <274761730>; samsung,dc-value = <25>; }; /* MAX77802 is on i2c bus 4 */ i2c@12CA0000 { clock-frequency = <400000>; power-regulator@9 { compatible = "maxim,max77802-pmic"; reg = <0x9>; }; }; i2c@12CD0000 { /* i2c7 */ clock-frequency = <100000>; soundcodec@20 { reg = <0x20>; compatible = "maxim,max98090-codec"; }; }; sound@3830000 { samsung,codec-type = "max98090"; }; i2c@12E10000 { /* i2c9 */ clock-frequency = <400000>; tpm@20 { compatible = "infineon,slb9645tt"; reg = <0x20>; }; }; spi@12d30000 { /* spi1 */ spi-max-frequency = <50000000>; firmware_storage_spi: flash@0 { reg = <0>; /* * A region for the kernel to store a panic event * which the firmware will add to the log. */ elog-panic-event-offset = <0x01e00000 0x100000>; elog-shrink-size = <0x400>; elog-full-threshold = <0xc00>; }; }; xhci@12000000 { samsung,vbus-gpio = <&gph0 0 GPIO_ACTIVE_HIGH>; }; xhci@12400000 { samsung,vbus-gpio = <&gph0 1 GPIO_ACTIVE_HIGH>; }; fimd@14400000 { samsung,vl-freq = <60>; samsung,vl-col = <1920>; samsung,vl-row = <1080>; samsung,vl-width = <1920>; samsung,vl-height = <1080>; samsung,vl-clkp; samsung,vl-dp; samsung,vl-bpix = <4>; samsung,vl-hspw = <80>; samsung,vl-hbpd = <172>; samsung,vl-hfpd = <60>; samsung,vl-vspw = <10>; samsung,vl-vbpd = <25>; samsung,vl-vfpd = <10>; samsung,vl-cmd-allow-len = <0xf>; samsung,power-on-delay = <30000>; samsung,winid = <3>; samsung,interface-mode = <1>; samsung,dp-enabled = <1>; samsung,dual-lcd-enabled = <0>; samsung,bl-en-gpio = <&gpx2 2 GPIO_ACTIVE_HIGH>; }; }; &dp { status = "okay"; samsung,color-space = <0>; samsung,dynamic-range = <0>; samsung,ycbcr-coeff = <0>; samsung,color-depth = <1>; samsung,link-rate = <0x0a>; samsung,lane-count = <2>; samsung,hpd-gpio = <&gpx2 6 GPIO_ACTIVE_HIGH>; ports { port { dp_out: endpoint { remote-endpoint = <&panel_in>; }; }; }; }; &spi_2 { spi-max-frequency = <3125000>; spi-deactivate-delay = <200>; status = "okay"; num-cs = <1>; samsung,spi-src-clk = <0>; cs-gpios = <&gpb1 2 0>; cros_ec: cros-ec@0 { compatible = "google,cros-ec-spi"; interrupt-parent = <&gpx1>; interrupts = <5 0>; reg = <0>; spi-half-duplex; spi-max-timeout-ms = <1100>; ec-interrupt = <&gpx1 5 GPIO_ACTIVE_LOW>; /* * This describes the flash memory within the EC. Note * that the STM32L flash erases to 0, not 0xff. */ #address-cells = <1>; #size-cells = <1>; flash@8000000 { reg = <0x08000000 0x20000>; erase-value = <0>; }; controller-data { samsung,spi-feedback-delay = <1>; }; i2c_tunnel: i2c-tunnel { compatible = "google,cros-ec-i2c-tunnel"; #address-cells = <1>; #size-cells = <0>; google,remote-bus = <0>; battery: sbs-battery@b { compatible = "sbs,sbs-battery"; reg = <0xb>; sbs,poll-retry-count = <1>; sbs,i2c-retry-count = <2>; }; power-regulator@48 { compatible = "ti,tps65090"; reg = <0x48>; regulators { tps65090_dcdc1: dcdc1 { ti,enable-ext-control; }; tps65090_dcdc2: dcdc2 { ti,enable-ext-control; }; tps65090_dcdc3: dcdc3 { ti,enable-ext-control; }; tps65090_fet1: fet1 { regulator-name = "vcd_led"; }; tps65090_fet2: fet2 { regulator-name = "video_mid"; regulator-always-on; }; tps65090_fet3: fet3 { regulator-name = "wwan_r"; regulator-always-on; }; tps65090_fet4: fet4 { regulator-name = "sdcard"; regulator-always-on; }; tps65090_fet5: fet5 { regulator-name = "camout"; regulator-always-on; }; tps65090_fet6: fet6 { regulator-name = "lcd_vdd"; }; tps65090_fet7: fet7 { regulator-name = "video_mid_1a"; regulator-always-on; }; tps65090_ldo1: ldo1 { }; tps65090_ldo2: ldo2 { }; }; charger { compatible = "ti,tps65090-charger"; }; }; }; }; }; #include "cros-ec-keyboard.dtsi"