From a7403ae84d15096330d6b08b11b1a4b03da38abf Mon Sep 17 00:00:00 2001 From: Hans de Goede Date: Thu, 22 Jan 2015 21:02:42 +0100 Subject: sunxi: video: Make pwm polarity configurable It turns out that there are some panels where the pwm input is not active low, so make it configurable. Signed-off-by: Hans de Goede Acked-by: Ian Campbell --- drivers/video/sunxi_display.c | 17 +++++++++++------ 1 file changed, 11 insertions(+), 6 deletions(-) (limited to 'drivers') diff --git a/drivers/video/sunxi_display.c b/drivers/video/sunxi_display.c index 5077111daf..af728b51c7 100644 --- a/drivers/video/sunxi_display.c +++ b/drivers/video/sunxi_display.c @@ -23,6 +23,14 @@ #include "hitachi_tx18d42vm_lcd.h" #include "ssd2828.h" +#ifdef CONFIG_VIDEO_LCD_BL_PWM_ACTIVE_LOW +#define PWM_ON 0 +#define PWM_OFF 1 +#else +#define PWM_ON 1 +#define PWM_OFF 0 +#endif + DECLARE_GLOBAL_DATA_PTR; enum sunxi_monitor { @@ -598,8 +606,7 @@ static void sunxi_lcdc_panel_enable(void) pin = sunxi_name_to_gpio(CONFIG_VIDEO_LCD_BL_PWM); if (pin != -1) { gpio_request(pin, "lcd_backlight_pwm"); - /* backlight pwm is inverted, set to 1 to disable backlight */ - gpio_direction_output(pin, 1); + gpio_direction_output(pin, PWM_OFF); } /* Give the backlight some time to turn off and power up the panel. */ @@ -626,10 +633,8 @@ static void sunxi_lcdc_backlight_enable(void) gpio_direction_output(pin, 1); pin = sunxi_name_to_gpio(CONFIG_VIDEO_LCD_BL_PWM); - if (pin != -1) { - /* backlight pwm is inverted, set to 0 to enable backlight */ - gpio_direction_output(pin, 0); - } + if (pin != -1) + gpio_direction_output(pin, PWM_ON); } static int sunxi_lcdc_get_clk_delay(const struct ctfb_res_modes *mode) -- cgit v1.2.1