From f70444980b23f5f52025aa6b7d22233312dea136 Mon Sep 17 00:00:00 2001 From: Hans de Goede Date: Sat, 13 Dec 2014 12:40:45 +0100 Subject: sunxi: axp221: Add Kconfig help and sane defaults for typical ldo usage Some of the ldo-s of the axp221 are used in the same way on most boards, add comments to the Kconfig help text to reflect this, and give them defaults matching their typical usage. Signed-off-by: Hans de Goede Acked-by: Ian Campbell --- drivers/power/Kconfig | 20 ++++++++++++++------ 1 file changed, 14 insertions(+), 6 deletions(-) (limited to 'drivers/power/Kconfig') diff --git a/drivers/power/Kconfig b/drivers/power/Kconfig index 7373a793e2..af66887129 100644 --- a/drivers/power/Kconfig +++ b/drivers/power/Kconfig @@ -12,7 +12,9 @@ config AXP221_DLDO1_VOLT default -1 ---help--- Set the voltage (mV) to program the axp221 dldo1 at, set to -1 to - disable dldo1. + disable dldo1. On sun6i (A31) boards with ethernet this is often used + to power the ethernet phy. On sun8i (A23) boards this is often used to + power the wifi. config AXP221_DLDO4_VOLT int "axp221 dldo4 voltage" @@ -28,20 +30,26 @@ config AXP221_ALDO1_VOLT default -1 ---help--- Set the voltage (mV) to program the axp221 aldo1 at, set to -1 to - disable aldo1. + disable aldo1. On sun6i (A31) boards which have a wifi module this is + often used to power the wifi module. config AXP221_ALDO2_VOLT int "axp221 aldo2 voltage" depends on AXP221_POWER - default -1 + default 1800 if MACH_SUN6I + default 2500 if MACH_SUN8I ---help--- Set the voltage (mV) to program the axp221 aldo2 at, set to -1 to - disable aldo2. + disable aldo2. On sun6i (A31) boards this is typically connected to + VCC-PM, which powers the port M gpios, and should be set to 1.8V. + On sun8i (A23) this is typically connected to VDD-DLL and must be + set to 2.5V. config AXP221_ALDO3_VOLT int "axp221 aldo3 voltage" depends on AXP221_POWER - default -1 + default 3000 ---help--- Set the voltage (mV) to program the axp221 aldo3 at, set to -1 to - disable aldo3. + disable aldo3. This is typically connected to VCC-PLL and AVCC and + must be set to 3V. -- cgit v1.2.1