From df486b1fa3f750b153eac7daa0b3bf1f594e5098 Mon Sep 17 00:00:00 2001 From: Nicolas Ferre Date: Sun, 22 Mar 2009 14:48:16 +0100 Subject: at91: Support for the at91sam9g20 : Atmel 400Mhz ARM 926ej-s SOC. AT91sam9g20 is an evolution of the at91sam9260 with a faster clock speed. The AT91SAM9G20-EK board is an updated revision of the AT91SAM9260-EK board. It is essentially the same, with a few minor differences. Here is the chip page on Atmel website: http://www.atmel.com/dyn/products/product_card.asp?part_id=4337 Signed-off-by: Justin Waters Signed-off-by: Nicolas Ferre Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD --- drivers/net/macb.c | 4 ++-- 1 file changed, 2 insertions(+), 2 deletions(-) (limited to 'drivers/net/macb.c') diff --git a/drivers/net/macb.c b/drivers/net/macb.c index af0409bd2c..6de0a04410 100644 --- a/drivers/net/macb.c +++ b/drivers/net/macb.c @@ -447,14 +447,14 @@ static int macb_init(struct eth_device *netdev, bd_t *bd) /* choose RMII or MII mode. This depends on the board */ #ifdef CONFIG_RMII #if defined(CONFIG_AT91CAP9) || defined(CONFIG_AT91SAM9260) || \ - defined(CONFIG_AT91SAM9263) + defined(CONFIG_AT91SAM9263) || defined(CONFIG_AT91SAM9G20) macb_writel(macb, USRIO, MACB_BIT(RMII) | MACB_BIT(CLKEN)); #else macb_writel(macb, USRIO, 0); #endif #else #if defined(CONFIG_AT91CAP9) || defined(CONFIG_AT91SAM9260) || \ - defined(CONFIG_AT91SAM9263) + defined(CONFIG_AT91SAM9263) || defined(CONFIG_AT91SAM9G20) macb_writel(macb, USRIO, MACB_BIT(CLKEN)); #else macb_writel(macb, USRIO, MACB_BIT(MII)); -- cgit v1.2.1