From c5c1af21764d9423b45c1d03e835c4547a8bc5cb Mon Sep 17 00:00:00 2001 From: Chin Liang See Date: Mon, 30 Dec 2013 18:26:14 -0600 Subject: socfpga/dwmmc: Adding DesignWare MMC driver support for SOCFPGA To add the DesignWare MMC driver support for Altera SOCFPGA. It required information such as clocks and bus width from platform specific files (SOCFPGA handoff files) Signed-off-by: Chin Liang See Cc: Rajeshwari Shinde Cc: Jaehoon Chung Cc: Pantelis Antoniou Cc: Wolfgang Denk Acked-by: Pantelis Antoniou --- doc/README.socfpga | 53 +++++++++++++++++++++++++++++++++++++++++++++++++++++ 1 file changed, 53 insertions(+) create mode 100644 doc/README.socfpga (limited to 'doc') diff --git a/doc/README.socfpga b/doc/README.socfpga new file mode 100644 index 0000000000..cfcbbfe379 --- /dev/null +++ b/doc/README.socfpga @@ -0,0 +1,53 @@ + +-------------------------------------------- +SOCFPGA Documentation for U-Boot and SPL +-------------------------------------------- + +This README is about U-Boot and SPL support for Altera's ARM Cortex-A9MPCore +based SOCFPGA. To know more about the hardware itself, please refer to +www.altera.com. + + +-------------------------------------------- +socfpga_dw_mmc +-------------------------------------------- +Here are macro and detailed configuration required to enable DesignWare SDMMC +controller support within SOCFPGA + +#define CONFIG_MMC +-> To enable the SD MMC framework support + +#define CONFIG_SDMMC_BASE (SOCFPGA_SDMMC_ADDRESS) +-> The base address of CSR register for DesignWare SDMMC controller + +#define CONFIG_GENERIC_MMC +-> Enable the generic MMC driver + +#define CONFIG_SYS_MMC_MAX_BLK_COUNT 256 +-> Using smaller max blk cnt to avoid flooding the limited stack in OCRAM + +#define CONFIG_DWMMC +-> Enable the common DesignWare SDMMC controller framework + +#define CONFIG_SOCFPGA_DWMMC +-> Enable the SOCFPGA specific driver for DesignWare SDMMC controller + +#define CONFIG_SOCFPGA_DWMMC_FIFO_DEPTH 1024 +-> The FIFO depth for SOCFPGA DesignWare SDMMC controller + +#define CONFIG_SOCFPGA_DWMMC_DRVSEL 3 +-> Phase-shifted clock of sdmmc_clk for controller to drive command and data to +the card to meet hold time requirements. SD clock is running at 50MHz and +drvsel is set to shift 135 degrees (3 * 45 degrees). With that, the hold time +is 135 / 360 * 20ns = 7.5ns. + +#define CONFIG_SOCFPGA_DWMMC_SMPSEL 0 +-> Phase-shifted clock of sdmmc_clk used to sample the command and data from +the card + +#define CONFIG_SOCFPGA_DWMMC_BUS_WIDTH 4 +-> Bus width of data line which either 1, 4 or 8 and based on board routing. + +#define CONFIG_SOCFPGA_DWMMC_BUS_HZ 50000000 +-> The clock rate to controller. Do note the controller have a wrapper which +divide the clock from PLL by 4. -- cgit v1.2.1