From 17f3f366528230da68e08b3b01a048fefa4c5752 Mon Sep 17 00:00:00 2001 From: Fabio Estevam Date: Fri, 3 May 2013 15:08:01 -0300 Subject: mx28evk: Move README file inside board directory Board specific READMEs should be located inside the respective board directory. Signed-off-by: Fabio Estevam --- doc/README.mx28evk | 46 ---------------------------------------------- 1 file changed, 46 deletions(-) delete mode 100644 doc/README.mx28evk (limited to 'doc') diff --git a/doc/README.mx28evk b/doc/README.mx28evk deleted file mode 100644 index 524f3fc494..0000000000 --- a/doc/README.mx28evk +++ /dev/null @@ -1,46 +0,0 @@ -FREESCALE MX28EVK -================== - -Supported hardware: only MX28EVK rev D is supported in U-boot. - -Files of the MX28EVK port --------------------------- - -arch/arm/cpu/arm926ejs/mxs/ - The CPU support code for the Freescale i.MX28 -arch/arm/include/asm/arch-mxs/ - Header files for the Freescale i.MX28 -board/freescale/mx28evk/ - MX28EVK board specific files -include/configs/mx28evk.h - MX28EVK configuration file - -Jumper configuration ---------------------- - -To boot MX28EVK from an SD card, set the boot mode DIP switches as: - - * Boot Mode Select: 1 0 0 1 (Boot from SD card Slot 0 - U42) - * JTAG PSWITCH RESET: To the right (reset disabled) - * Battery Source: Down - * Wall 5V: Up - * VDD 5V: To the left (off) - * Hold Button: Down (off) - - -Environment Storage -------------------- - -There are two targets for mx28evk: - -"make mx28evk_config" - store enviroment variables into MMC - -or - -"make mx28evk_nand_config" - store enviroment variables into NAND flash - -Choose the target accordingly. - -Note: The mx28evk board does not come with a NAND flash populated from the -factory. It comes with an empty slot (U23), which allows the insertion of a -48-pin TSOP flash device. - -Follow the instructions from doc/README.mxs to generate a bootable SD card. - -Insert the SD card in slot 0, power up the board and U-boot will boot. -- cgit v1.2.1