From f321b0f99fa0ccf1f25b3d9ab2140b98baa6fdbd Mon Sep 17 00:00:00 2001 From: Gabor Juhos Date: Thu, 24 Jan 2013 06:27:52 +0000 Subject: MIPS: start.S: set sp register directly The current code uses two instructions to load the stack pointer into the 'sp' register. This results in the following assembly code: 468: 3c088040 lui t0,0x8040 46c: 251d0000 addiu sp,t0,0 The first instuction loads the stack pointer into the 't0' register then the value of the 'sp' register is computed by adding zero to the value of the 't0' register. The same issue present on the 64-bit version as well: 56c: 3c0c8040 lui t0,0x8040 570: 659d0000 daddiu sp,t0,0 Change the code to load the stack pointer directly into the 'sp' register. The generated code is functionally equivalent to the previous version but it is simpler. 32-bit: 468: 3c1d8040 lui sp,0x8040 64-bit: 56c: 3c1d8040 lui sp,0x8040 Signed-off-by: Gabor Juhos Cc: Daniel Schwierzeck --- arch/mips/cpu/mips64/start.S | 3 +-- 1 file changed, 1 insertion(+), 2 deletions(-) (limited to 'arch/mips/cpu/mips64') diff --git a/arch/mips/cpu/mips64/start.S b/arch/mips/cpu/mips64/start.S index aed82e1f07..d3c5ceaffd 100644 --- a/arch/mips/cpu/mips64/start.S +++ b/arch/mips/cpu/mips64/start.S @@ -137,8 +137,7 @@ reset: #endif /* Set up temporary stack */ - dli t0, CONFIG_SYS_SDRAM_BASE + CONFIG_SYS_INIT_SP_OFFSET - dla sp, 0(t0) + dli sp, CONFIG_SYS_SDRAM_BASE + CONFIG_SYS_INIT_SP_OFFSET dla t9, board_init_f jr t9 -- cgit v1.2.1