From 012681b1fa822492bb8fdc5c2dd3d24d6092e110 Mon Sep 17 00:00:00 2001 From: Heiko Schocher Date: Thu, 28 May 2015 07:27:36 +0200 Subject: am33xx, spl, siemens: enable debug uart output again a6b541b090: TI ARMv7: Don't use GD before crt0.S has set it moves the init of the debug uart at the very end of SPL code. Enable it for the siemens board earlier, as they print ddr settings ... all debug output before board_init_r() is here currently useless. Maybe we must rework this globally? Signed-off-by: Heiko Schocher --- board/siemens/common/board.c | 5 +++++ 1 file changed, 5 insertions(+) diff --git a/board/siemens/common/board.c b/board/siemens/common/board.c index cc0ac6b0bd..fb2de48fbc 100644 --- a/board/siemens/common/board.c +++ b/board/siemens/common/board.c @@ -43,6 +43,11 @@ void set_mux_conf_regs(void) /* Initalize the board header */ enable_i2c0_pin_mux(); i2c_set_bus_num(0); + + /* enable early the console */ + gd->baudrate = CONFIG_BAUDRATE; + serial_init(); + gd->have_console = 1; if (read_eeprom() < 0) puts("Could not get board ID.\n"); -- cgit v1.2.1