summaryrefslogtreecommitdiffstats
path: root/drivers/serial/ns16550.c
Commit message (Collapse)AuthorAgeFilesLines
* ZOOM2 Add serial support.Tom Rix2009-06-121-2/+2
| | | | | | | | | | | | | | | | | | Zoom2 serial is in general supplied by one of the 4 UARTS on the debug board. The default serial is from the USB connector on left side of the debug board. The USB connector will produce 2 of the 4 UARTS. On your host pick the first enumeration. The details of the setting of the serial gpmc setup are not available. The values were provided by another party. The serial port set up is the same with Zoom1. Baud rate 115200, 8 bit data, no parity, 1 stop bit, no flow. The kernel bootargs are console=ttyS3,115200n8 Signed-off-by: Tom Rix <Tom.Rix@windriver.com>
* Rename common ns16550 constants with UART_ prefix to prevent conflictsDetlev Zundel2009-04-031-18/+21
| | | | | | | | | | | | Fix problems introduced in commit 7b5611cdd12ca0cc33f994f0d4a4454788fc3124 [inka4x0: Add hardware diagnosis functions for inka4x0] which redefined MSR_RI which is already used on PowerPC systems. Also eliminate redundant definitions in ps2mult.h. More cleanup will be needed for other redundant occurrences though. Signed-off-by: Detlev Zundel <dzu@denx.de>
* drivers/serial/ns16550: move ifdef into Makefile COBJS-$(...)Mike Frysinger2009-02-211-5/+1
| | | | Signed-off-by: Mike Frysinger <vapier@gentoo.org>
* Create configuration option for restricted ns16550 functionsRon Madrid2009-02-191-0/+4
| | | | | | | | | | | This patch will create a configuration option for a minimum configuration for the ns16550 serial driver at drivers/serial/ns16550.c and will apply this new configuration option to the SIMPC8313.h config file in order to fix the NAND bootstrap build error. This option will exclude all functions with exception of NS16550_putc and NS16550_init. This will be used primarily to save space and remove unused code from builds in which space is limited. Signed-off-by: Ron Madrid <ron_madrid@sbcglobal.net>
* rename CFG_ macros to CONFIG_SYSJean-Christophe PLAGNIOL-VILLARD2008-10-181-2/+2
| | | | Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>
* OMAP5912: fix FIFO handling in UART driverWolfgang Denk2008-02-051-4/+12
| | | | | | | | | | | | According to the OMAP5912 Serial Interfaces Reference Guide (see http://focus.ti.com/lit/ug/spru760c/spru760c.pdf, page 150), the FIFO_EN enable bit in the FIFO Control Register (FCR) can only be changed when the baud clock is not running, i. e. when both DLL and DLH are set to 0. Thus make sure that DLL and DLH are 0 when writing the FCR. Signed-off-by: Wolfgang Denk <wd@denx.de>
* drivers/serial : move serial drivers to drivers/serialJean-Christophe PLAGNIOL-VILLARD2007-11-251-0/+71
Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>
OpenPOWER on IntegriCloud