diff options
Diffstat (limited to 'doc')
| -rw-r--r-- | doc/device-tree-bindings/gpio/intel,x86-broadwell-pinctrl.txt | 208 |
1 files changed, 208 insertions, 0 deletions
diff --git a/doc/device-tree-bindings/gpio/intel,x86-broadwell-pinctrl.txt b/doc/device-tree-bindings/gpio/intel,x86-broadwell-pinctrl.txt new file mode 100644 index 0000000000..a644381e0a --- /dev/null +++ b/doc/device-tree-bindings/gpio/intel,x86-broadwell-pinctrl.txt @@ -0,0 +1,208 @@ +Intel x86 PINCTRL/GPIO controller + +Pin-muxing on broadwell devices can be described with a node for the PINCTRL +master node and a set of child nodes for each required pin state on the SoC. +These pin states use phandles and are referred to but a configuration section +which lists all pins in the device. + +The PINCTRL master node requires the following properties: +- compatible : "intel,x86-broadwell-pinctrl" + +Pin state nodes must be sub-nodes of the pinctrl master node. The must have +a phandle. They can contain the following optional properties: +- mode-gpio - forces the pin into GPIO mode +- output-value - sets the default output value of the GPIO, 0 (low, default) + or 1 (high) +- direction - sets the direction of the gpio, either PIN_INPUT (default) + or PIN_OUTPUT +- invert - the input pin is inverted +- trigger - sets the trigger type, either TRIGGER_EDGE (default) or + TRIGGER_LEVEL +- sense-disable - the input state sense is disabled +- owner 0 sets the owner of the pin, either OWNER_ACPI (default) or + ONWER_GPIO +- route - sets whether the pin is routed, either PIRQ_APIC_MASK or + PIRQ_APIC_ROUTE +- irq-enable - the interrupt is enabled +- reset-rsmrst - the pin will only be reset by RSMRST +- pirq-apic - the pin will be routed to the IOxAPIC + +The first pin state will be the default, so pins without a configuration will +use that. + +The pin configuration node is also a sub-node of the pinctrl master node, but +does not have a phandle. It has a single property: + +- config - configuration to use for each pin. Each entry has of 3 cells: + - GPIO number (0..94) + - phandle of configuration (above) + - interrupt number (0..15) + + There should be one entry for each pin (i.e. 95 entries). + But missing pins will receive the default configuration. + +Example: + +pch_pinctrl { + compatible = "intel,x86-broadwell-pinctrl"; + + /* Put this first: it is the default */ + gpio_unused: gpio-unused { + mode-gpio; + direction = <PIN_INPUT>; + owner = <OWNER_GPIO>; + sense-disable; + }; + + gpio_acpi_sci: acpi-sci { + mode-gpio; + direction = <PIN_INPUT>; + invert; + route = <ROUTE_SCI>; + }; + + gpio_acpi_smi: acpi-smi { + mode-gpio; + direction = <PIN_INPUT>; + invert; + route = <ROUTE_SMI>; + }; + + gpio_input: gpio-input { + mode-gpio; + direction = <PIN_INPUT>; + owner = <OWNER_GPIO>; + }; + + gpio_input_invert: gpio-input-invert { + mode-gpio; + direction = <PIN_INPUT>; + owner = <OWNER_GPIO>; + invert; + }; + + gpio_native: gpio-native { + }; + + gpio_out_high: gpio-out-high { + mode-gpio; + direction = <PIN_OUTPUT>; + output-value = <1>; + owner = <OWNER_GPIO>; + sense-disable; + }; + + gpio_out_low: gpio-out-low { + mode-gpio; + direction = <PIN_OUTPUT>; + output-value = <0>; + owner = <OWNER_GPIO>; + sense-disable; + }; + + gpio_pirq: gpio-pirq { + mode-gpio; + direction = <PIN_INPUT>; + owner = <OWNER_GPIO>; + pirq-apic = <PIRQ_APIC_ROUTE>; + }; + + soc_gpio@0 { + config = + <0 &gpio_unused 0>, /* unused */ + <1 &gpio_unused 0>, /* unused */ + <2 &gpio_unused 0>, /* unused */ + <3 &gpio_unused 0>, /* unused */ + <4 &gpio_native 0>, /* native: i2c0_sda_gpio4 */ + <5 &gpio_native 0>, /* native: i2c0_scl_gpio5 */ + <6 &gpio_native 0>, /* native: i2c1_sda_gpio6 */ + <7 &gpio_native 0>, /* native: i2c1_scl_gpio7 */ + <8 &gpio_acpi_sci 0>, /* pch_lte_wake_l */ + <9 &gpio_input_invert 0>,/* trackpad_int_l (wake) */ + <10 &gpio_acpi_sci 0>, /* pch_wlan_wake_l */ + <11 &gpio_unused 0>, /* unused */ + <12 &gpio_unused 0>, /* unused */ + <13 &gpio_pirq 3>, /* trackpad_int_l (pirql) */ + <14 &gpio_pirq 4>, /* touch_int_l (pirqm) */ + <15 &gpio_unused 0>, /* unused (strap) */ + <16 &gpio_input 0>, /* pch_wp */ + <17 &gpio_unused 0>, /* unused */ + <18 &gpio_unused 0>, /* unused */ + <19 &gpio_unused 0>, /* unused */ + <20 &gpio_native 0>, /* pcie_wlan_clkreq_l */ + <21 &gpio_out_high 0>, /* pp3300_ssd_en */ + <22 &gpio_unused 0>, /* unused */ + <23 &gpio_out_low 0>, /* pp3300_autobahn_en */ + <24 &gpio_unused 0>, /* unused */ + <25 &gpio_input 0>, /* ec_in_rw */ + <26 &gpio_unused 0>, /* unused */ + <27 &gpio_acpi_sci 0>, /* pch_wake_l */ + <28 &gpio_unused 0>, /* unused */ + <29 &gpio_unused 0>, /* unused */ + <30 &gpio_native 0>, /* native: pch_suswarn_l */ + <31 &gpio_native 0>, /* native: acok_buf */ + <32 &gpio_native 0>, /* native: lpc_clkrun_l */ + <33 &gpio_native 0>, /* native: ssd_devslp */ + <34 &gpio_acpi_smi 0>, /* ec_smi_l */ + <35 &gpio_acpi_smi 0>, /* pch_nmi_dbg_l (route in nmi_en) */ + <36 &gpio_acpi_sci 0>, /* ec_sci_l */ + <37 &gpio_unused 0>, /* unused */ + <38 &gpio_unused 0>, /* unused */ + <39 &gpio_unused 0>, /* unused */ + <40 &gpio_native 0>, /* native: pch_usb1_oc_l */ + <41 &gpio_native 0>, /* native: pch_usb2_oc_l */ + <42 &gpio_unused 0>, /* wlan_disable_l */ + <43 &gpio_out_high 0>, /* pp1800_codec_en */ + <44 &gpio_unused 0>, /* unused */ + <45 &gpio_acpi_sci 0>, /* dsp_int - codec wake */ + <46 &gpio_pirq 6>, /* hotword_det_l_3v3 (pirqo) - codec irq */ + <47 &gpio_out_low 0>, /* ssd_reset_l */ + <48 &gpio_unused 0>, /* unused */ + <49 &gpio_unused 0>, /* unused */ + <50 &gpio_unused 0>, /* unused */ + <51 &gpio_unused 0>, /* unused */ + <52 &gpio_input 0>, /* sim_det */ + <53 &gpio_unused 0>, /* unused */ + <54 &gpio_unused 0>, /* unused */ + <55 &gpio_unused 0>, /* unused */ + <56 &gpio_unused 0>, /* unused */ + <57 &gpio_out_high 0>, /* codec_reset_l */ + <58 &gpio_unused 0>, /* unused */ + <59 &gpio_out_high 0>, /* lte_disable_l */ + <60 &gpio_unused 0>, /* unused */ + <61 &gpio_native 0>, /* native: pch_sus_stat */ + <62 &gpio_native 0>, /* native: pch_susclk */ + <63 &gpio_native 0>, /* native: pch_slp_s5_l */ + <64 &gpio_unused 0>, /* unused */ + <65 &gpio_input 0>, /* ram_id3 */ + <66 &gpio_input 0>, /* ram_id3_old (strap) */ + <67 &gpio_input 0>, /* ram_id0 */ + <68 &gpio_input 0>, /* ram_id1 */ + <69 &gpio_input 0>, /* ram_id2 */ + <70 &gpio_unused 0>, /* unused */ + <71 &gpio_native 0>, /* native: modphy_en */ + <72 &gpio_unused 0>, /* unused */ + <73 &gpio_unused 0>, /* unused */ + <74 &gpio_unused 0>, /* unused */ + <75 &gpio_unused 0>, /* unused */ + <76 &gpio_unused 0>, /* unused */ + <77 &gpio_unused 0>, /* unused */ + <78 &gpio_unused 0>, /* unused */ + <79 &gpio_unused 0>, /* unused */ + <80 &gpio_unused 0>, /* unused */ + <81 &gpio_unused 0>, /* unused */ + <82 &gpio_native 0>, /* native: ec_rcin_l */ + <83 &gpio_native 0>, /* gspi0_cs */ + <84 &gpio_native 0>, /* gspi0_clk */ + <85 &gpio_native 0>, /* gspi0_miso */ + <86 &gpio_native 0>, /* gspi0_mosi (strap) */ + <87 &gpio_unused 0>, /* unused */ + <88 &gpio_unused 0>, /* unused */ + <89 &gpio_out_high 0>, /* pp3300_sd_en */ + <90 &gpio_unused 0>, /* unused */ + <91 &gpio_unused 0>, /* unused */ + <92 &gpio_unused 0>, /* unused */ + <93 &gpio_unused 0>, /* unused */ + <94 &gpio_unused 0 >; /* unused */ + }; +}; |
