diff options
Diffstat (limited to 'doc')
| -rw-r--r-- | doc/README.nand | 23 | ||||
| -rw-r--r-- | doc/README.omap3 | 3 |
2 files changed, 24 insertions, 2 deletions
diff --git a/doc/README.nand b/doc/README.nand index 487548fcb8..b91f1985d1 100644 --- a/doc/README.nand +++ b/doc/README.nand @@ -208,6 +208,29 @@ Platform specific options detection. However ECC calculation on such plaforms would still be done by GPMC controller. + CONFIG_NAND_OMAP_ECCSCHEME + On OMAP platforms, this CONFIG specifies NAND ECC scheme. + It can take following values: + OMAP_ECC_HAM1_CODE_SW + 1-bit Hamming code using software lib. + (for legacy devices only) + OMAP_ECC_HAM1_CODE_HW + 1-bit Hamming code using GPMC hardware. + (for legacy devices only) + OMAP_ECC_BCH4_CODE_HW_DETECTION_SW + 4-bit BCH code (unsupported) + OMAP_ECC_BCH4_CODE_HW + 4-bit BCH code (unsupported) + OMAP_ECC_BCH8_CODE_HW_DETECTION_SW + 8-bit BCH code with + - ecc calculation using GPMC hardware engine, + - error detection using software library. + - requires CONFIG_BCH to enable software BCH library + (For legacy device which do not have ELM h/w engine) + OMAP_ECC_BCH8_CODE_HW + 8-bit BCH code with + - ecc calculation using GPMC hardware engine, + - error detection using ELM hardware engine. NOTE: ===== diff --git a/doc/README.omap3 b/doc/README.omap3 index 1fbe79db37..a62c357405 100644 --- a/doc/README.omap3 +++ b/doc/README.omap3 @@ -161,8 +161,7 @@ BCH8 To enable hardware assisted BCH8 (8-bit BCH [Bose, Chaudhuri, Hocquenghem]) on OMAP3 devices we can use the BCH library in lib/bch.c. To do so add CONFIG_BCH -to enable the library and CONFIG_NAND_OMAP_BCH8 to to enable hardware assisted -syndrom generation to your board config. +and set CONFIG_NAND_OMAP_ECCSCHEME=5 (refer README.nand) for selecting BCH8_SW. The NAND OOB layout is the same as in linux kernel, if the linux kernel BCH8 implementation for OMAP3 works for you so the u-boot version should also. When you require the SPL to read with BCH8 there are two more configs to |
