diff options
Diffstat (limited to 'board/sixnet/sixnet.c')
| -rw-r--r-- | board/sixnet/sixnet.c | 22 |
1 files changed, 11 insertions, 11 deletions
diff --git a/board/sixnet/sixnet.c b/board/sixnet/sixnet.c index dcd34726b0..3ed581ec09 100644 --- a/board/sixnet/sixnet.c +++ b/board/sixnet/sixnet.c @@ -35,7 +35,7 @@ #if defined(CONFIG_CMD_NAND) #include <linux/mtd/nand_legacy.h> -extern struct nand_chip nand_dev_desc[CFG_MAX_NAND_DEVICE]; +extern struct nand_chip nand_dev_desc[CONFIG_SYS_MAX_NAND_DEVICE]; #endif DECLARE_GLOBAL_DATA_PTR; @@ -133,7 +133,7 @@ const uint duart_table[] = #define FPGA_DONE 0x0080 /* PA8, input, high when FPGA load complete */ #define FPGA_PROGRAM_L 0x0040 /* PA9, output, low to reset, high to start */ #define FPGA_INIT_L 0x0020 /* PA10, input, low indicates not ready */ -#define fpga (*(volatile unsigned char *)(CFG_FPGA_PROG)) /* FPGA port */ +#define fpga (*(volatile unsigned char *)(CONFIG_SYS_FPGA_PROG)) /* FPGA port */ int board_postclk_init (void) { @@ -143,7 +143,7 @@ int board_postclk_init (void) # include "fpgadata.c" }; - volatile immap_t *immap = (immap_t *)CFG_IMMR; + volatile immap_t *immap = (immap_t *)CONFIG_SYS_IMMR; volatile memctl8xx_t *memctl = &immap->im_memctl; #define porta (immap->im_ioport.iop_padat) const unsigned char* pdata; @@ -247,10 +247,10 @@ int board_postclk_init (void) /* ------------------------------------------------------------------------- */ /* base address for SRAM, assume 32-bit port, valid */ -#define NVRAM_BR_VALUE (CFG_SRAM_BASE | BR_PS_32 | BR_V) +#define NVRAM_BR_VALUE (CONFIG_SYS_SRAM_BASE | BR_PS_32 | BR_V) /* up to 64MB - will be adjusted for actual size */ -#define NVRAM_OR_PRELIM (ORMASK(CFG_SRAM_SIZE) \ +#define NVRAM_OR_PRELIM (ORMASK(CONFIG_SYS_SRAM_SIZE) \ | OR_CSNT_SAM | OR_ACS_DIV4 | OR_BI | OR_SCY_5_CLK | OR_EHTR) /* * Miscellaneous platform dependent initializations after running in RAM. @@ -258,7 +258,7 @@ int board_postclk_init (void) int misc_init_r (void) { - volatile immap_t *immap = (immap_t *)CFG_IMMR; + volatile immap_t *immap = (immap_t *)CONFIG_SYS_IMMR; volatile memctl8xx_t *memctl = &immap->im_memctl; char* s; char* e; @@ -271,7 +271,7 @@ int misc_init_r (void) /* Is there any SRAM? Is it 16 or 32 bits wide? */ /* First look for 32-bit SRAM */ - bd->bi_sramsize = ram_size((ulong*)CFG_SRAM_BASE, CFG_SRAM_SIZE); + bd->bi_sramsize = ram_size((ulong*)CONFIG_SYS_SRAM_BASE, CONFIG_SYS_SRAM_SIZE); if (bd->bi_sramsize == 0) { /* no 32-bit SRAM, but there could be 16-bit SRAM since @@ -279,7 +279,7 @@ int misc_init_r (void) * Try again with a 16-bit bus. */ memctl->memc_br2 |= BR_PS_16; - bd->bi_sramsize = ram_size((ulong*)CFG_SRAM_BASE, CFG_SRAM_SIZE); + bd->bi_sramsize = ram_size((ulong*)CONFIG_SYS_SRAM_BASE, CONFIG_SYS_SRAM_SIZE); } if (bd->bi_sramsize == 0) { @@ -288,7 +288,7 @@ int misc_init_r (void) else { /* adjust or2 for actual size of SRAM */ memctl->memc_or2 |= ORMASK(bd->bi_sramsize); - bd->bi_sramstart = CFG_SRAM_BASE; + bd->bi_sramstart = CONFIG_SYS_SRAM_BASE; printf("SRAM: %lu KB\n", bd->bi_sramsize >> 10); } @@ -330,7 +330,7 @@ int misc_init_r (void) #if defined(CONFIG_CMD_NAND) void nand_init(void) { - unsigned long totlen = nand_probe(CFG_DFLASH_BASE); + unsigned long totlen = nand_probe(CONFIG_SYS_DFLASH_BASE); printf ("%4lu MB\n", totlen >> 20); } @@ -498,7 +498,7 @@ const uint sdram_table[] = phys_size_t initdram(int board_type) { - volatile immap_t *immap = (immap_t *)CFG_IMMR; + volatile immap_t *immap = (immap_t *)CONFIG_SYS_IMMR; volatile memctl8xx_t *memctl = &immap->im_memctl; uint size_sdram = 0; uint size_sdram9 = 0; |
