diff options
Diffstat (limited to 'board/mpl/mip405/mip405.c')
| -rw-r--r-- | board/mpl/mip405/mip405.c | 56 |
1 files changed, 42 insertions, 14 deletions
diff --git a/board/mpl/mip405/mip405.c b/board/mpl/mip405/mip405.c index 07922bc989..090041b403 100644 --- a/board/mpl/mip405/mip405.c +++ b/board/mpl/mip405/mip405.c @@ -69,6 +69,7 @@ #include <miiphy.h> #include "../common/common_util.h" #include <i2c.h> +#include <rtc.h> extern block_dev_desc_t * scsi_get_dev(int dev); extern block_dev_desc_t * ide_get_dev(int dev); @@ -110,14 +111,14 @@ typedef struct { } sdram_t; #if defined(CONFIG_MIP405T) const sdram_t sdram_table[] = { - { 0x01, /* MIP405T Rev A, 64MByte -1 Board */ + { 0x0F, /* MIP405T Rev A, 64MByte -1 Board */ 3, /* Case Latenty = 3 */ 3, /* trp 20ns / 7.5 ns datain[27] */ 3, /* trcd 20ns /7.5 ns (datain[29]) */ 6, /* tras 44ns /7.5 ns (datain[30]) */ 4, /* tcpt 44 - 20ns = 24ns */ - 3, /* Address Mode = 3 (13x9x4) */ - 4, /* size value (64MByte) */ + 2, /* Address Mode = 2 (12x9x4) */ + 3, /* size value (32MByte) */ 0}, /* ECC disabled */ { 0xff, /* terminator */ 0xff, @@ -281,11 +282,6 @@ int init_sdram (void) if((bc & 0x80)==0x80) SDRAM_err ("U-Boot configured for a MIP405 not for a MIP405T!!!\n"); #endif -#if !defined(CONFIG_MIP405T) - /* since the ECC initialisation needs some time, - * we show that we're alive - */ - serial_puts ("\nInitializing SDRAM, Please stand by"); /* set-up the chipselect machine */ mtdcr (ebccfga, pb0cr); /* get cs0 config reg */ tmp = mfdcr (ebccfgd); @@ -311,7 +307,6 @@ int init_sdram (void) mtdcr (ebccfgd, UART1_AP); mtdcr (ebccfga, pb3cr); mtdcr (ebccfgd, UART1_CR); -#endif bc = in8 (PLD_BOARD_CFG_REG); #ifdef SDRAM_DEBUG serial_puts ("\nstart SDRAM Setup\n"); @@ -333,6 +328,11 @@ int init_sdram (void) write_hex (i); serial_puts (" \n"); #endif + /* since the ECC initialisation needs some time, + * we show that we're alive + */ + if (sdram_table[i].ecc) + serial_puts ("\nInitializing SDRAM, Please stand by"); cal_val = sdram_table[i].cal - 1; /* Cas Latency */ trp_clocks = sdram_table[i].trp; /* 20ns / 7.5 ns datain[27] */ trcd_clocks = sdram_table[i].trcd; /* 20ns /7.5 ns (datain[29]) */ @@ -559,7 +559,7 @@ void get_pcbrev_var(unsigned char *pcbrev, unsigned char *var) unsigned char bc; bc = in8 (PLD_BOARD_CFG_REG); *pcbrev=(bc >> 4) & 0xf; - *var=bc & 0xf ; + *var=16-(bc & 0xf); #endif } @@ -654,8 +654,6 @@ long int initdram (int board_type) /* ------------------------------------------------------------------------- */ -extern int mem_test (unsigned long start, unsigned long ramsize, - int quiet); static int test_dram (unsigned long ramsize) { @@ -666,8 +664,15 @@ static int test_dram (unsigned long ramsize) return (1); } +/* used to check if the time in RTC is valid */ +static unsigned long start; +static struct rtc_time tm; + int misc_init_r (void) { + /* check, if RTC is running */ + rtc_get (&tm); + start=get_timer(0); /* if MIP405 has booted from PCI, reset CCR0[24] as described in errata PCI_18 */ if (mfdcr(strap) & PSR_ROM_LOC) mtspr(ccr0, (mfspr(ccr0) & ~0x80)); @@ -688,9 +693,13 @@ void print_mip405_rev (void) } extern void mem_test_reloc(void); +extern int mk_date (char *, struct rtc_time *); int last_stage_init (void) { + unsigned long stop; + struct rtc_time newtm; + unsigned char *s; mem_test_reloc(); /* write correct LED configuration */ if (miiphy_write (0x1, 0x14, 0x2402) != 0) { @@ -704,6 +713,25 @@ int last_stage_init (void) print_mip405_rev (); show_stdio_dev (); check_env (); + /* check if RTC time is valid */ + stop=get_timer(start); + while(stop<1200) { /* we wait 1.2 sec to check if the RTC is running */ + udelay(1000); + stop=get_timer(start); + } + rtc_get (&newtm); + if(tm.tm_sec==newtm.tm_sec) { + s=getenv("defaultdate"); + if(!s) + mk_date ("010112001970", &newtm); + else + if(mk_date (s, &newtm)!=0) { + printf("RTC: Bad date format in defaultdate\n"); + return 0; + } + rtc_reset (); + rtc_set(&newtm); + } return 0; } @@ -745,10 +773,10 @@ void print_mip405_info (void) printf ("SER1 uses handshakes %s\n", (ext & 0x80) ? "DTR/DSR" : "RTS/CTS"); #else - printf ("User Config Switch %d %d %d %d %d %d %d %d %d\n", + printf ("User Config Switch %d %d %d %d %d %d %d %d\n", (ext) & 0x1, (ext >> 1) & 0x1, (ext >> 2) & 0x1, (ext >> 3) & 0x1, (ext >> 4) & 0x1, (ext >> 5) & 0x1, - (ext >> 6) & 0x1,(ext >> 7) & 0x1,(ext >> 8) & 0x1); + (ext >> 6) & 0x1,(ext >> 7) & 0x1); #endif printf ("IDE Reset %s\n", (ext & 0x01) ? "asserted" : "not asserted"); printf ("IRQs:\n"); |
