diff options
| -rw-r--r-- | arch/arm/cpu/armv7/zynq/slcr.c | 26 | ||||
| -rw-r--r-- | arch/arm/include/asm/arch-zynq/hardware.h | 7 | ||||
| -rw-r--r-- | arch/arm/include/asm/arch-zynq/sys_proto.h | 1 | ||||
| -rw-r--r-- | drivers/net/zynq_gem.c | 53 |
4 files changed, 71 insertions, 16 deletions
diff --git a/arch/arm/cpu/armv7/zynq/slcr.c b/arch/arm/cpu/armv7/zynq/slcr.c index 788a8fd14f..5a8674ab2c 100644 --- a/arch/arm/cpu/armv7/zynq/slcr.c +++ b/arch/arm/cpu/armv7/zynq/slcr.c @@ -61,3 +61,29 @@ void zynq_slcr_cpu_reset(void) writel(1, &slcr_base->pss_rst_ctrl); } + +/* Setup clk for network */ +void zynq_slcr_gem_clk_setup(u32 gem_id, u32 rclk, u32 clk) +{ + zynq_slcr_unlock(); + + if (gem_id > 1) { + printf("Non existing GEM id %d\n", gem_id); + goto out; + } + + if (gem_id) { + /* Set divisors for appropriate frequency in GEM_CLK_CTRL */ + writel(clk, &slcr_base->gem1_clk_ctrl); + /* Configure GEM_RCLK_CTRL */ + writel(rclk, &slcr_base->gem1_rclk_ctrl); + } else { + /* Set divisors for appropriate frequency in GEM_CLK_CTRL */ + writel(clk, &slcr_base->gem0_clk_ctrl); + /* Configure GEM_RCLK_CTRL */ + writel(rclk, &slcr_base->gem0_rclk_ctrl); + } + +out: + zynq_slcr_lock(); +} diff --git a/arch/arm/include/asm/arch-zynq/hardware.h b/arch/arm/include/asm/arch-zynq/hardware.h index ccbf54e040..d8e378ff55 100644 --- a/arch/arm/include/asm/arch-zynq/hardware.h +++ b/arch/arm/include/asm/arch-zynq/hardware.h @@ -33,7 +33,12 @@ struct slcr_regs { u32 scl; /* 0x0 */ u32 slcr_lock; /* 0x4 */ u32 slcr_unlock; /* 0x8 */ - u32 reserved1[125]; + u32 reserved0[75]; + u32 gem0_rclk_ctrl; /* 0x138 */ + u32 gem1_rclk_ctrl; /* 0x13c */ + u32 gem0_clk_ctrl; /* 0x140 */ + u32 gem1_clk_ctrl; /* 0x144 */ + u32 reserved1[46]; u32 pss_rst_ctrl; /* 0x200 */ u32 reserved2[15]; u32 fpga_rst_ctrl; /* 0x240 */ diff --git a/arch/arm/include/asm/arch-zynq/sys_proto.h b/arch/arm/include/asm/arch-zynq/sys_proto.h index e78890011a..57128dc40e 100644 --- a/arch/arm/include/asm/arch-zynq/sys_proto.h +++ b/arch/arm/include/asm/arch-zynq/sys_proto.h @@ -26,5 +26,6 @@ extern void zynq_slcr_lock(void); extern void zynq_slcr_unlock(void); extern void zynq_slcr_cpu_reset(void); +extern void zynq_slcr_gem_clk_setup(u32 gem_id, u32 rclk, u32 clk); #endif /* _SYS_PROTO_H_ */ diff --git a/drivers/net/zynq_gem.c b/drivers/net/zynq_gem.c index 7758cf89c2..2d717e9103 100644 --- a/drivers/net/zynq_gem.c +++ b/drivers/net/zynq_gem.c @@ -33,6 +33,7 @@ #include <phy.h> #include <miiphy.h> #include <watchdog.h> +#include <asm/arch/sys_proto.h> #if !defined(CONFIG_PHYLIB) # error XILINX_GEM_ETHERNET requires PHYLIB @@ -67,13 +68,14 @@ #define ZYNQ_GEM_NWCTRL_MDEN_MASK 0x00000010 /* Enable MDIO port */ #define ZYNQ_GEM_NWCTRL_STARTTX_MASK 0x00000200 /* Start tx (tx_go) */ -#define ZYNQ_GEM_NWCFG_SPEED 0x00000001 /* 100 Mbps operation */ -#define ZYNQ_GEM_NWCFG_FDEN 0x00000002 /* Full Duplex mode */ -#define ZYNQ_GEM_NWCFG_FSREM 0x00020000 /* FCS removal */ +#define ZYNQ_GEM_NWCFG_SPEED100 0x000000001 /* 100 Mbps operation */ +#define ZYNQ_GEM_NWCFG_SPEED1000 0x000000400 /* 1Gbps operation */ +#define ZYNQ_GEM_NWCFG_FDEN 0x000000002 /* Full Duplex mode */ +#define ZYNQ_GEM_NWCFG_FSREM 0x000020000 /* FCS removal */ #define ZYNQ_GEM_NWCFG_MDCCLKDIV 0x000080000 /* Div pclk by 32, 80MHz */ +#define ZYNQ_GEM_NWCFG_MDCCLKDIV2 0x0000c0000 /* Div pclk by 48, 120MHz */ -#define ZYNQ_GEM_NWCFG_INIT (ZYNQ_GEM_NWCFG_SPEED | \ - ZYNQ_GEM_NWCFG_FDEN | \ +#define ZYNQ_GEM_NWCFG_INIT (ZYNQ_GEM_NWCFG_FDEN | \ ZYNQ_GEM_NWCFG_FSREM | \ ZYNQ_GEM_NWCFG_MDCCLKDIV) @@ -227,7 +229,7 @@ static int zynq_gem_setup_mac(struct eth_device *dev) static int zynq_gem_init(struct eth_device *dev, bd_t * bis) { - u32 i; + u32 i, rclk, clk = 0; struct phy_device *phydev; const u32 stat_size = (sizeof(struct zynq_gem_regs) - offsetof(struct zynq_gem_regs, stat)) / 4; @@ -277,16 +279,11 @@ static int zynq_gem_init(struct eth_device *dev, bd_t * bis) /* Write RxBDs to IP */ writel((u32)&(priv->rx_bd), ®s->rxqbase); - /* MAC Setup */ - /* Setup Network Configuration register */ - writel(ZYNQ_GEM_NWCFG_INIT, ®s->nwcfg); - /* Setup for DMA Configuration register */ writel(ZYNQ_GEM_DMACR_INIT, ®s->dmacr); /* Setup for Network Control register, MDIO, Rx and Tx enable */ - setbits_le32(®s->nwctrl, ZYNQ_GEM_NWCTRL_MDEN_MASK | - ZYNQ_GEM_NWCTRL_RXEN_MASK | ZYNQ_GEM_NWCTRL_TXEN_MASK); + setbits_le32(®s->nwctrl, ZYNQ_GEM_NWCTRL_MDEN_MASK); priv->init++; } @@ -294,12 +291,38 @@ static int zynq_gem_init(struct eth_device *dev, bd_t * bis) /* interface - look at tsec */ phydev = phy_connect(priv->bus, priv->phyaddr, dev, 0); - phydev->supported &= supported; + phydev->supported = supported | ADVERTISED_Pause | + ADVERTISED_Asym_Pause; phydev->advertising = phydev->supported; priv->phydev = phydev; phy_config(phydev); phy_startup(phydev); + switch (phydev->speed) { + case SPEED_1000: + writel(ZYNQ_GEM_NWCFG_INIT | ZYNQ_GEM_NWCFG_SPEED1000, + ®s->nwcfg); + rclk = (0 << 4) | (1 << 0); + clk = (1 << 20) | (8 << 8) | (0 << 4) | (1 << 0); + break; + case SPEED_100: + clrsetbits_le32(®s->nwcfg, ZYNQ_GEM_NWCFG_SPEED1000, + ZYNQ_GEM_NWCFG_INIT | ZYNQ_GEM_NWCFG_SPEED100); + rclk = 1 << 0; + clk = (5 << 20) | (8 << 8) | (0 << 4) | (1 << 0); + break; + case SPEED_10: + rclk = 1 << 0; + /* FIXME untested */ + clk = (5 << 20) | (8 << 8) | (0 << 4) | (1 << 0); + break; + } + /* FIXME maybe better to define gem address in hardware.h */ + zynq_slcr_gem_clk_setup(dev->iobase != 0xE000B000, rclk, clk); + + setbits_le32(®s->nwctrl, ZYNQ_GEM_NWCTRL_RXEN_MASK | + ZYNQ_GEM_NWCTRL_TXEN_MASK); + return 0; } @@ -380,8 +403,8 @@ static void zynq_gem_halt(struct eth_device *dev) { struct zynq_gem_regs *regs = (struct zynq_gem_regs *)dev->iobase; - /* Disable the receiver & transmitter */ - writel(0, ®s->nwctrl); + clrsetbits_le32(®s->nwctrl, ZYNQ_GEM_NWCTRL_RXEN_MASK | + ZYNQ_GEM_NWCTRL_TXEN_MASK, 0); } static int zynq_gem_miiphyread(const char *devname, uchar addr, |
