powerpc: mpc85xx: Support booting from SD Card with SPL

The code from the internal on-chip ROM. It loads the final uboot image
into DDR, then jump to it to begin execution.

The SPL's size is sizeable, the maximum size must not exceed the size of L2
SRAM. It initializes the DDR through SPD code, and copys final uboot image
to DDR. So there are two stage uboot images:
	* spl_boot, 96KB size. The env variables are copied to L2 SRAM, so that
	ddr spd code can get the interleaving mode setting in env. It loads
	final uboot image from offset 96KB.
	* final uboot image, size is variable depends on the functions enabled.

Signed-off-by: Ying Zhang <b40530@freescale.com>
Acked-by: York Sun <yorksun@freescale.com>

1 files changed, 4 insertions, 0 deletions

diff --git a/arch/powerpc/cpu/mpc8xxx/ddr/lc_common_dimm_params.c b/arch/powerpc/cpu/mpc8xxx/ddr/lc_common_dimm_params.c
index e958e138dd..56128a7b96 100644
--- a/arch/powerpc/cpu/mpc8xxx/ddr/lc_common_dimm_params.c
+++ b/arch/powerpc/cpu/mpc8xxx/ddr/lc_common_dimm_params.c
@@ -218,12 +218,16 @@ compute_lowest_common_dimm_parameters(const dimm_params_t *dimm_params,
 		if (dimm_params[i].n_ranks) {
 			if (dimm_params[i].registered_dimm) {
 				temp1 = 1;
+#ifndef CONFIG_SPL_BUILD
 				printf("Detected RDIMM %s\n",
 					dimm_params[i].mpart);
+#endif
 			} else {
 				temp2 = 1;
+#ifndef CONFIG_SPL_BUILD
 				printf("Detected UDIMM %s\n",
 					dimm_params[i].mpart);
+#endif
 			}
 		}
 	}