arm: armada-xp: Add basic support for Marvell Armada XP SoC

This basic support for the Marvell Armada XP is base on the existing kirkwood
support. Which has been generatized by moving some common files into
common marvell locations.

This is in preparation for the upcoming Armada XP MV78460 support.

Signed-off-by: Stefan Roese <sr@denx.de>
Tested-by: Luka Perkov <luka@openwrt.org>

3 files changed, 246 insertions, 0 deletions

diff --git a/arch/arm/include/asm/arch-armada-xp/config.h b/arch/arm/include/asm/arch-armada-xp/config.h
new file mode 100644
index 0000000000..00ee775a45
--- /dev/null
+++ b/arch/arm/include/asm/arch-armada-xp/config.h
@@ -0,0 +1,82 @@
+/*
+ * (C) Copyright 2011
+ * Marvell Semiconductor <www.marvell.com>
+ * Written-by: Lei Wen <leiwen@marvell.com>
+ *
+ * SPDX-License-Identifier:	GPL-2.0+
+ */
+
+/*
+ * This file should be included in board config header file.
+ *
+ * It supports common definitions for Armada XP platforms
+ */
+
+#ifndef _ARMADA_XP_CONFIG_H
+#define _ARMADA_XP_CONFIG_H
+
+#include <asm/arch/soc.h>
+
+#define MV88F78X60 /* for the DDR training bin_hdr code */
+
+#define CONFIG_SYS_CACHELINE_SIZE	32
+
+/*
+ * By default kwbimage.cfg from board specific folder is used
+ * If for some board, different configuration file need to be used,
+ * CONFIG_SYS_KWD_CONFIG should be defined in board specific header file
+ */
+#ifndef CONFIG_SYS_KWD_CONFIG
+#define	CONFIG_SYS_KWD_CONFIG	$(CONFIG_BOARDDIR)/kwbimage.cfg
+#endif /* CONFIG_SYS_KWD_CONFIG */
+
+/* Add target to build it automatically upon "make" */
+#define CONFIG_BUILD_TARGET	"u-boot.kwb"
+
+/* end of 16M scrubbed by training in bootrom */
+#define CONFIG_SYS_INIT_SP_ADDR		0x00FF0000
+#define CONFIG_NR_DRAM_BANKS_MAX	2
+
+#define MV_UART_CONSOLE_BASE		MVEBU_UART0_BASE
+
+/*
+ * SPI Flash configuration
+ */
+#ifdef CONFIG_CMD_SF
+#define CONFIG_HARD_SPI			1
+#define CONFIG_KIRKWOOD_SPI		1
+#ifndef CONFIG_ENV_SPI_BUS
+# define CONFIG_ENV_SPI_BUS		0
+#endif
+#ifndef CONFIG_ENV_SPI_CS
+# define CONFIG_ENV_SPI_CS		0
+#endif
+#ifndef CONFIG_ENV_SPI_MAX_HZ
+# define CONFIG_ENV_SPI_MAX_HZ		50000000
+#endif
+#endif
+
+/*
+ * Ethernet Driver configuration
+ */
+#ifdef CONFIG_CMD_NET
+#define CONFIG_CMD_MII
+#define CONFIG_MII		/* expose smi ove miiphy interface */
+#define CONFIG_MVNETA		/* Enable Marvell Gbe Controller Driver */
+#define CONFIG_PHYLIB
+#define CONFIG_ENV_OVERWRITE	/* ethaddr can be reprogrammed */
+#define CONFIG_PHY_GIGE		/* GbE speed/duplex detect */
+#endif /* CONFIG_CMD_NET */
+
+/*
+ * I2C related stuff
+ */
+#ifdef CONFIG_CMD_I2C
+#ifndef CONFIG_SYS_I2C_SOFT
+#define CONFIG_I2C_MVTWSI
+#endif
+#define CONFIG_SYS_I2C_SLAVE		0x0
+#define CONFIG_SYS_I2C_SPEED		100000
+#endif
+
+#endif /* _ARMADA_XP_CONFIG_H */
diff --git a/arch/arm/include/asm/arch-armada-xp/cpu.h b/arch/arm/include/asm/arch-armada-xp/cpu.h
new file mode 100644
index 0000000000..6b60c21ceb
--- /dev/null
+++ b/arch/arm/include/asm/arch-armada-xp/cpu.h
@@ -0,0 +1,107 @@
+/*
+ * (C) Copyright 2009
+ * Marvell Semiconductor <www.marvell.com>
+ * Written-by: Prafulla Wadaskar <prafulla@marvell.com>
+ *
+ * SPDX-License-Identifier:	GPL-2.0+
+ */
+
+#ifndef _ARMADA_XP_CPU_H
+#define _ARMADA_XP_CPU_H
+
+#include <asm/system.h>
+
+#ifndef __ASSEMBLY__
+
+#define MVEBU_REG_PCIE_DEVID		(MVEBU_REG_PCIE_BASE + 0x00)
+#define MVEBU_REG_PCIE_REVID		(MVEBU_REG_PCIE_BASE + 0x08)
+
+enum memory_bank {
+	BANK0,
+	BANK1,
+	BANK2,
+	BANK3
+};
+
+enum cpu_winen {
+	CPU_WIN_DISABLE,
+	CPU_WIN_ENABLE
+};
+
+enum cpu_target {
+	CPU_TARGET_DRAM = 0x0,
+	CPU_TARGET_DEVICEBUS_BOOTROM_SPI = 0x1,
+	CPU_TARGET_ETH23 = 0x3,
+	CPU_TARGET_PCIE02 = 0x4,
+	CPU_TARGET_ETH01 = 0x7,
+	CPU_TARGET_PCIE13 = 0x8,
+	CPU_TARGET_SASRAM = 0x9,
+	CPU_TARGET_NAND = 0xd,
+};
+
+enum cpu_attrib {
+	CPU_ATTR_SASRAM = 0x01,
+	CPU_ATTR_DRAM_CS0 = 0x0e,
+	CPU_ATTR_DRAM_CS1 = 0x0d,
+	CPU_ATTR_DRAM_CS2 = 0x0b,
+	CPU_ATTR_DRAM_CS3 = 0x07,
+	CPU_ATTR_NANDFLASH = 0x2f,
+	CPU_ATTR_SPIFLASH = 0x1e,
+	CPU_ATTR_BOOTROM = 0x1d,
+	CPU_ATTR_PCIE_IO = 0xe0,
+	CPU_ATTR_PCIE_MEM = 0xe8,
+	CPU_ATTR_DEV_CS0 = 0x3e,
+	CPU_ATTR_DEV_CS1 = 0x3d,
+	CPU_ATTR_DEV_CS2 = 0x3b,
+	CPU_ATTR_DEV_CS3 = 0x37,
+};
+
+/*
+ * Default Device Address MAP BAR values
+ */
+#define DEFADR_PCI_MEM		0x90000000
+#define DEFADR_PCI_IO		0xC0000000
+#define DEFADR_SPIF		0xF4000000
+#define DEFADR_BOOTROM		0xF8000000
+
+struct mbus_win {
+	u32 base;
+	u32 size;
+	u8 target;
+	u8 attr;
+};
+
+/*
+ * System registers
+ * Ref: Datasheet sec:A.28
+ */
+struct mvebu_system_registers {
+	u8 pad1[0x60];
+	u32 rstoutn_mask; /* 0x60 */
+	u32 sys_soft_rst; /* 0x64 */
+};
+
+/*
+ * GPIO Registers
+ * Ref: Datasheet sec:A.19
+ */
+struct kwgpio_registers {
+	u32 dout;
+	u32 oe;
+	u32 blink_en;
+	u32 din_pol;
+	u32 din;
+	u32 irq_cause;
+	u32 irq_mask;
+	u32 irq_level;
+};
+
+/*
+ * functions
+ */
+unsigned int mvebu_sdram_bar(enum memory_bank bank);
+unsigned int mvebu_sdram_bs(enum memory_bank bank);
+void mvebu_sdram_size_adjust(enum memory_bank bank);
+int mvebu_mbus_probe(struct mbus_win windows[], int count);
+#endif /* __ASSEMBLY__ */
+#endif /* _ARMADA_XP_CPU_H */
diff --git a/arch/arm/include/asm/arch-armada-xp/soc.h b/arch/arm/include/asm/arch-armada-xp/soc.h
new file mode 100644
index 0000000000..963e7ac5b7
--- /dev/null
+++ b/arch/arm/include/asm/arch-armada-xp/soc.h
@@ -0,0 +1,57 @@
+/*
+ * (C) Copyright 2009
+ * Marvell Semiconductor <www.marvell.com>
+ * Written-by: Prafulla Wadaskar <prafulla@marvell.com>
+ *
+ * Header file for the Marvell's Feroceon CPU core.
+ *
+ * SPDX-License-Identifier:	GPL-2.0+
+ */
+
+#ifndef _ASM_ARCH_ARMADA_XP_H
+#define _ASM_ARCH_ARMADA_XP_H
+
+#define SOC_MV78460_ID		0x7846
+
+/* TCLK Core Clock definition */
+#ifndef CONFIG_SYS_TCLK
+#define CONFIG_SYS_TCLK		250000000	/* 250MHz */
+#endif
+
+/* SOC specific definations */
+#define INTREG_BASE		0xd0000000
+#define INTREG_BASE_ADDR_REG	(INTREG_BASE + 0x20080)
+#define SOC_REGS_PHY_BASE	0xf1000000
+#define MVEBU_REGISTER(x)	(SOC_REGS_PHY_BASE + x)
+
+#define MVEBU_SDRAM_SCRATCH	(MVEBU_REGISTER(0x01504))
+#define MVEBU_SPI_BASE		(MVEBU_REGISTER(0x10600))
+#define MVEBU_TWSI_BASE		(MVEBU_REGISTER(0x11000))
+#define MVEBU_UART0_BASE	(MVEBU_REGISTER(0x12000))
+#define MVEBU_UART1_BASE	(MVEBU_REGISTER(0x12100))
+#define MVEBU_MPP_BASE		(MVEBU_REGISTER(0x18000))
+#define MVEBU_GPIO0_BASE	(MVEBU_REGISTER(0x18100))
+#define MVEBU_GPIO1_BASE	(MVEBU_REGISTER(0x18140))
+#define MVEBU_GPIO2_BASE	(MVEBU_REGISTER(0x18180))
+#define MVEBU_SYSTEM_REG_BASE	(MVEBU_REGISTER(0x18200))
+#define MVEBU_CPU_WIN_BASE	(MVEBU_REGISTER(0x20000))
+#define MVEBU_SDRAM_BASE	(MVEBU_REGISTER(0x20180))
+#define MVEBU_TIMER_BASE	(MVEBU_REGISTER(0x20300))
+#define MVEBU_EGIGA2_BASE	(MVEBU_REGISTER(0x30000))
+#define MVEBU_EGIGA3_BASE	(MVEBU_REGISTER(0x34000))
+#define MVEBU_REG_PCIE_BASE	(MVEBU_REGISTER(0x40000))
+#define MVEBU_EGIGA0_BASE	(MVEBU_REGISTER(0x70000))
+#define MVEBU_EGIGA1_BASE	(MVEBU_REGISTER(0x74000))
+
+#define SDRAM_MAX_CS		4
+#define SDRAM_ADDR_MASK		0xFF000000
+
+/* Armada XP GbE controller has 4 ports */
+#define MAX_MVNETA_DEVS		4
+
+/* Kirkwood CPU memory windows */
+#define MVCPU_WIN_CTRL_DATA	CPU_WIN_CTRL_DATA
+#define MVCPU_WIN_ENABLE	CPU_WIN_ENABLE
+#define MVCPU_WIN_DISABLE	CPU_WIN_DISABLE
+
+#endif /* _ASM_ARCH_ARMADA_XP_H */