From 8fccdb580ebec0f5b081d824797911a4c5d91891 Mon Sep 17 00:00:00 2001 From: Martin Blumenstingl Date: Sun, 27 Mar 2016 17:43:02 +0200 Subject: gpio: gpio-it87: Add support for IT8620 and IT8628 These chips seem to have a 9th GPIO block (thus supporting 72 GPIOs) which is configured through SuperIO register 0xd2 (output enable) and 0xd3 (simple I/O). This is also the reason why io_size is larger than on IT8728 / IT8732. Unfortunately I don't have hardware to test this 9th GPIO block. I am also not sure about not configuring the Simple I/O registers as the hardware I have only uses GPIO block 8. Reading back the values of 0xc0-0xc7 (as configured by the BIOS/EFI on my board) shows that all have 0xff set. Signed-off-by: Martin Blumenstingl Signed-off-by: Linus Walleij --- drivers/gpio/gpio-it87.c | 10 ++++++++++ 1 file changed, 10 insertions(+) (limited to 'drivers/gpio/gpio-it87.c') diff --git a/drivers/gpio/gpio-it87.c b/drivers/gpio/gpio-it87.c index b219c82414bf..63a962d18cd6 100644 --- a/drivers/gpio/gpio-it87.c +++ b/drivers/gpio/gpio-it87.c @@ -34,6 +34,8 @@ /* Chip Id numbers */ #define NO_DEV_ID 0xffff +#define IT8620_ID 0x8620 +#define IT8628_ID 0x8628 #define IT8728_ID 0x8728 #define IT8732_ID 0x8732 #define IT8761_ID 0x8761 @@ -302,6 +304,14 @@ static int __init it87_gpio_init(void) it87_gpio->chip = it87_template_chip; switch (chip_type) { + case IT8620_ID: + case IT8628_ID: + gpio_ba_reg = 0x62; + it87_gpio->io_size = 11; + it87_gpio->output_base = 0xc8; + it87_gpio->simple_size = 0; + it87_gpio->chip.ngpio = 64; + break; case IT8728_ID: case IT8732_ID: gpio_ba_reg = 0x62; -- cgit v1.2.1